Papers by Author: Jing Nan Cai

Abstract: We present Mg and Ti co-doped NiO-based polycrystalline ceramic with high-permittivity dielectric properties. Analysis of the ceramic’s microstructure and composition proves that obvious grain boundaries NiTiO3 are formed. The measurements of frequency and temperature dependence of impedance and dielectric permittivity indicate that the grain and grain boundaries have remarkable influence on the dielectric properties due to the various activation energies.

Abstract: Ni-Si-O thin films on Si substrate have been prepared by a sol-gel method. The microstructure and phase composition of the films were investigated by XRD, SEM, FTIR. The XRD results showed that the films are amorphous while annealed at 800oC for 10 min, the SEM imagines proved that the films are smooth and thickness is about 190 nm. Electrical property of the film indicated that the leakage current was as low as 10-6A/cm2 at an electric field of 1MV/cm. The dielectric properties of Ni-Si-O thin films can be improved as increasing the annealed temperature.

Abstract: ZnO-Pr6O11-Dy2O3-based varistor ceramics doped with 0~1.5 mol% La2O3 were fabricated by a conventional ceramic method. All the samples were sintered at 1350 oC
for 2 h. The phase composition and microstructure of the ceramic samples have been investigated by XRD, SEM and EDS. The results of SEM micrographs indicated that the La2O3 additives can promote ZnO grain’s growth, and the rare earth elements dispersed mainly in the intergranular phase observed by EDS. The electrical properties of the samples determined by the V-I curves revealed that the breakdown voltage of samples decreases from 508 V/mm to about 100 V/mm with the increase of La2O3, and the nonlinear exponent also decreases from 20.2 to 13.2. The typical leakage current is about 10.2 μA for the sample doped with 0.5 mol% La2O3.