Papers by Author: Peng Juan Liu

Abstract: Significant progress has been made in thermoelectric materials during the last decades and it is found that thermoelectric thin film materials have high thermoelectric conversion efficiency. ZnO based thermoelectric materials, such as ZnO:Al (AZO), are considered as the most promising oxide materials for high-temperature, nontoxic and low-cost thermoelectric application. In this work, the effects of annealing temperature on the thermoelectric properties of AZO thin films prepared by direct current magnetron sputtering were investigated. The results indicate that the Seebeck coefficient of AZO thin films increases and the resistivity decreases as increasing of annealing temperature. Among the prepared AZO films in this work, the maximum absolute value of Seebeck coefficient is 460 μV/K and the minimum resistivity is 3.25×10^-4 Ω·m. The sample annealed at 773 K has a maximum power factor value of 1.46×10^-4 W/mK² at 620 K with a moderate Seebeck coefficient of-355 μV/K and a electrical conductivity of 1.16×10³ S/m.

Abstract: N-type Bi2Te3 and p-type Sb2Te3 thermoelectric thin films have been prepared by RF and DC co-sputtering. The Seebeck coefficient of n-type Bi2Te3 and p-type Sb2Te3 thin films is about -122 μVK-1 and 108 μVK-1, the power factor is about 0.82×10-3 Wm-1K-2 and 1.60×10-3 Wm-1K-2. Then, the films have been selected to fabricate the thin film thermoelectric generator. The results show that the open-circuit voltage of 12.2 mV and the output power of 3.32 μW are obtained for a thin film generator with the temperature difference at 60 K.

Abstract: Antimony (Sb) and zinc (Zn) bilayer was sputter-deposited at room temperature with various Zn contents by ion-beam sputtering and transformed into Antimony zinc after post thermal annealed at 573K for 60 min. A power factor of 6.18×10-4 W/mK2 at 473 K has been obtained when the sputtering time of the Zn was 20 minutes. The maximum Seebeck coefficient is 42.0 μVK-1. Composition analysis shows that the compound of SbZn is achieved and the small Seebeck coefficient is due to the deviation of stoichiometric.