Papers by Author: Wei Wang

Abstract: TiC reinforced titanium matrix functionally graded materials （FGM） has been produced by processes of laser metal deposition through changing the powder feed rate of Ti and Cr3C2 powder. The OM, SEM, EDS methods were used to analyze the components and microstructure of the coatings. Microhardness and wearing resistance at room temperature of the FGM coating were examined by microhardness tester and wear tester respectively. The results show that FGM coating reinforced by in-situ TiC apparently improved hardness of Ti alloy; the microhardness can reach HV1100, and present gradient distribution along deposition direction. Dry sliding wear properties of these FGM coatings have been compared with substrate materials wearing. The observed wearing mechanisms are summarized and related to detailed microstructural observations. The results show the wear resistance of the coating can be improved by 46.6 times.

Abstract: To increase the strength and erosion resistance of Copper Crystallizer, the system based on Laser Metal Deposition (LMD) process was proposed to clad nickel-based alloy on its surface. With the optimal processing parameters ascertained by large numbers of experiments, the crystallizer was clad nickel-based alloy. The morphology and the microstructures of the cladding layers and bonding interface were analyzed by energy dispersive spectrometer and scanning electronic microscopy. The result shows that the bonding interface realizes the metallurgic and tight bonding.

Abstract: Constructing the topology of STL file efficiently is a key factor to improve the efficiency of slicing algorithm. In this paper a topology construction algorithm based on Standard Template Library set containers and a rapid slicing algorithm are developed. The algorithm developed removes a large number of redundant vertices, and only calculates intersection per triangular facet with slice plane once, and attains another point of intersection directly from the adjacent relations. In addition, the algorithm can reduce the times of traversing and sorting for the triangular facets, and also the times of calculation of intersection in the slicing processes, which results in the simplification of the process of constructing the slice contour, consequently the efficiency of the slicing algorithm is improved.

Abstract: The functional and structural models of networked collaborative design system based on project management are brought forward in this paper. Its typical workflow is defined according to the system architecture. In process of studying implementation mechanism of collaborative design system, the algorithm of Fuzzy Analytic Hierarchy Process (F-AHP) is employed in choosing partners as personnel management mechanism, the method of Design Structure Matrix (DSM) is applied in process of decomposing and assigning design tasks, and weight-coefficient recursively statistic algorithm is used in controlling task schedule. The archetypal system of networked collaborative design based on project management is developed and tested, realization supported “multi-user &multi-task” is drown the conclusion.

Abstract: In the grinding process of special spiral rods, the actual feed rate is far below the allowable limit, resulting in great efficiency waste. To tackle the problem, this paper presents a controlling strategy which significantly improves rough grinding efficiency through changing grinding feed rate, enhances work-piece surface quality and shortens the processing time. Based on the establishment of the work cycle model of the special spiral rod grinding process, the strategy sets the grinding efficiency of each individual rod section as the objective function, thus via genetic algorithm realizes an optimal calculation on grinding feed rate variable and resolves the power and roundness constraint problem. Through computer simulation, an optimal grinding control plan is obtained which can help the grinding process to achieve overall optimization.