Papers by Keyword: Chemical Polymerization

Abstract: The role of formic acid as Secondary Dopant for Poly (O-toluidine) Intrinsically Doped with Camphor Sulfonic-Acid (POT-CSA) nanoparticles were prepared by chemical polymerization had been studied. Spin coating and casting method have been used to deposit good adhesion and uniform thin films of (POT-CSA) on a glass substrates at room temperature. the properties of (POT-CSA) nanoparticles which examined by FTIR, SEM, AFM, XRD, I-V characteristics and UV-VIS. FTIR studies show the several bending and stretching modes of POT. XRD examination demonstrated that NPS. has a semi-crystalline pattern . The synthesized film well covered by the nanoparticles over the entire substrate surface, exhibits uniform, porous, and spherical granular surface morphology, A narrow size distribution is observed and the average size of particles about 80 nm. The band gap (Eg) has been determined which is equal to 3.1 ev. The room temperature conductivity of POT-CSA was 3 * 10-1 S.cm-1,which increases with increasing temperature. Electrical conductivity enhances up to three order after the secondary doping process. Keywords: POT-Chemical polymerization-Conducting polymer-SEM-AFM

Abstract: In this work, the relation between oxidant/monomer ratio and the electrical conductivity of polypyrrole was studied using different ratios. We achieved a maximum value for electrical conductivity of 7.5 S/cm for a ratio of 2:1. We also developed a chemical dip-coating process to produce the cathode layer in tantalum capacitors. We obtained capacitances of about 80 µF after 8 cycles using the sequence Monomer/Oxidant.