Papers by Keyword: Liberation

Abstract: Since the metallic elements are covered with or encapsulated by various plastic or ceramic materials on printed circuit boards (PCBs), a pre-treatment process allowing their liberation and separation is first needed in order to facilitate proficient extraction. In this work, a fundamental study has been carried out to recover metallic concentrates from PCBs scraps. The most important step is to separate or release particles from the associated gangue minerals at the possible liberation particle size. The samples of printed circuit boards were separated into the magnetic and non-magnetic fractions by Rare-earth Roll Magnetic Separator. Then, the magnetic and non-magnetic fractions were separated to heavy fraction (metallic elements) and light fraction (plastic) by Mozley Laboratory Table Separator. Results show that the unliberated particles still remain in the comminution fines PCBs. The use of Rare-earth roll magnetic separation was clarified that the Fe, Ni and Zn element tend to be condensed in magnetic particles. Meanwhile Cu element tends to be release in non-magnetic particles. Mozley Laboratory Table Separation was capable to obtain fractions with relatively high concentrations of metallic elements. This study is expected to provide useful data for the efficient physical separation of metallic components from printed circuit boards scraps.

Abstract: Coal is a valuable natural resource for economic development. Clean coal and gangue can be liberated through grinding to improve the recovery of the clean coal. In this study, the mineral composition, size distribution of the raw coal and the grinding time test were investigated. The results showed that the main gangue minerals in the raw coal were kaolinite, quartz, illite, and smectite. The cumulative yield of ash increased sequentially with increasing grinding time. A longer grinding time corresponded to a higher degree of dissociation.

Abstract: The reutilization of waste Printed Circuit Boards (PCB) is a focused topic in the field of environment protection and resource recycling, and the crushing is the crucial process for recycling waste PCB. A hamper impacting crusher was used to achieve metals crushing liberation from non-metals, the liberation mechanism of PCB can be explained by dispersion liberation accompanied disengaging liberation. The Rosin-Rammler distribution model of crushed PCB particle was put forward. The evaluation indexes show that Rosin-Rammler function can accurately describe size distribution of PCB particles because the convergence property R2 is 0.99694 and fitting error E is 4.80658. The selective crushing is appearance with metals concentrated in coarser fraction and non-metals in finer size during comminution processing. The impact crushing is an effective method to metals liberation of PCB particles.