Papers by Keyword: Loose Abrasives

Abstract: Cd1−xZnxTe (CZT) is an excellent ternary compound semiconductor. CZT is the most suitable substrate material for Hg1−yCdyTe epitaxial growth and can make the detector itself. The researchers have done a lot of works on the hard and brittle material removal mechanism in lapping process. however, no published articles are available regarding the removal mechanism and the abrasives embedding mechanism of the soft and brittle material in lapping progress .and there is its own characteristic if the hard abrasives machining the soft and brittle material in lapping progress, the objective of this paper is to build the physical model ,and divide the abrasive into four kinds of abrasives , they are two-body abrasive ,three-body abrasive ,embedded abrasive and small abrasive, and the authors analyze the effects on the material surface of the above abrasives. At last, design series of experiments, through analyzing the results and observe the surface morphology, the authors prove that the physical model is correct.

Abstract: This paper proposes a sub-aperture grinding tool for loose abrasive computer controlled surfacing, which is designed to perform epicyclic motion and rotate around its centre at a rapid rate, whilst the entire mechanism revolves around a secondary centre at a slower rate. In actual process, the wear of the tool could affect the material removal function, and make the process unstable, thus in fact, it is difficult to make a deterministic manufacturing. The focus of the present paper is on wearing characteristics of sub-aperture tools and the wear evenness as the main objectives. To make a further study, material removal function of the tool is firstly established through theoretically modelling, next, a correlative function with weighted factors is built, which is suitable for specifying the wearing degree of the tool. Finally, to discover the relationship between the material removal rate and the tool wearing characteristics, and to optimize the grinding process, analysis and experiments are then carried out on a K9 glass specimen by means of three kinds of tool materials, i.e., polyurethane pad, aluminum plate and pitch based on the proposed technique and model. The results indicated that the required high efficiency and precision could be achieved by choosing proper processes.

Abstract: In this paper, three kinds of granite were lapped and polished by loose abrasives. Glossiness and surface roughness of the lapped and polished granites were measured and the surface morphologies were observed. The experimental results revealed that the readings of roughness were very discrete. High glossiness can be achieved only when the surface roughness is decreased to a certain level. The average surface roughness of the three kinds of granite after being finely polished can reach 0.02～0.04um. Further reducing of roughness has little effect on the glossiness because the existence of the defects, which prohibits the further increase of the glossiness.