Papers by Keyword: Silicon Condensation

Abstract: Chlorinated silicon precursor SiCl4 was investigated as a source of additional chlorine instead of or in combination with HCl during the low temperature (13000C) halo-carbon epitaxial growth. No Si cluster cloud was visible inside the hot-wall susceptor indicating negligible homogeneous gas-phase nucleation. The growth rate was significantly enhanced compared to the SiH4-case, but was relatively close to the SiH4+HCl case. Similar to the SiH4+HCl growth, the increase of the growth rate caused by suppressed cluster formation was less significant than expected. The depletion of the growth species by vigorous polycrystalline deposition upstream of the hot zone, which was earlier reported for the SiH4+HCl growth, was also significant in the SiCl4-based growth. Closer to the growth zone, carbon species also get incorporated in the polycrystalline deposits.

Abstract: In this work, nitrogen doping was investigated during the low-temperature halo-carbon epitaxial growth of 4H-SiC on Si- and C-faces. The dependencies of nitrogen incorporation on nitrogen flow rate, Si/C ratio, growth rate, and temperature were investigated. It was established that the efficiency of nitrogen incorporation for the C-face growth at 1300 °C is higher than that for the Si-face for a wide range of the growth conditions. Seeming deviation of the Si/C ratio dependence from the “site-competition” trend confirmed the critical role of the silicon vapor condensation during the low-temperature epitaxy. Opposite trends for the nitrogen doping dependence on the growth rate were observed on the Si- and C-faces. Finally, a complex temperature dependence of the nitrogen doping in the temperature range from 1300 to 1450 0C was observed.

Abstract: Low-temperature epitaxial growth of 4H-SiC with CH3Cl carbon precursor was further developed. In-situ doping with nitrogen and aluminum was investigated. The nitrogen concentration in epitaxial layers grown on the C face was almost two orders of magnitude higher than that in the Si-face epilayers grown in the same growth run at 13000C. The opposite trend was observed for intentional aluminum doping, with more than an order of magnitude higher aluminum concentration incorporated in Si-face epilayers. High values of nitrogen and aluminum doping well in excess of 1020 cm-3 without any obvious epilayer morphology degradation can be achieved on C-face and Siface respectively. Addition of HCl during halo-carbon growth at 13000C resulted in drastic improvement of the surface morphology. Also, a significant increase of the growth rate took place confirming that the improvement in the epilayer morphology during HCl-assisted growth is predominantly related to silicon cluster etching by additional Cl-containing vapor species.