Papers by Keyword: Warm-Wall Planetary Reactors

Abstract: Latest results are presented for SiC-epitaxial growths employing a novel 6x150-mm/10x100-mm Warm-Wall Planetary Vapor-Phase Epitaxial (VPE) Reactor. The increased throughput offered by this reactor and 150-mm diameter wafers, is intended to reduce the cost per unit area for SiC epitaxial layers, increasing the market penetration of already successful commercial SiC Schottky and MOSFET devices [1]. Increased growth rates of 30-40 micron/hr and short <2 hr fixed-cycle times (including rapid heat-up and cool-down ramps), while maintaining desirable epitaxial layer quality were achieved. Increased quantities of 150-mm epitaxial wafers now allow statistical analysis of their epitaxial layer properties. Specular epitaxial layer morphology was obtained, with morphological defect densities <0.4 cm^-2, consistent with projected 5x5 mm die yields averaging 93% for Si-face epitaxial layers between 10 and 30 microns thick. Intrawafer thickness and doping uniformity are good, averaging 1.7% and 5.1% respectively. Wafer-to-wafer doping variation has also been significantly reduced from ~12 [5] to <3% s/mean. Initial results for C-face growths show excellent morphology (97%) but poor doping uniformity (~16%). Wafer shape is relatively unchanged by epitaxial growth consistent with good epitaxial temperature uniformity.

Abstract: Initial results are presented for SiC-epitaxial growths employing a novel 6x150-mm/10x100-mm Warm-Wall Planetary Vapor-Phase Epitaxial (VPE) Reactor. The increased areal throughput offered by this reactor and 150-mm diameter wafers, is intended to reduce the cost per unit area for SiC epitaxial layers, increasing the market penetration of already successful commercial SiC Schottky and MOSFET devices [1]. Growth rates of 20 micron/hr and short <2 hr fixed-cycle times (including rapid heat-up and cool-down ramps), while maintaining desirable epitaxial layer quality were achieved. No significant change in 150 mm diameter wafer shape is observed upon epitaxial growth consistent with good-quality, low-stress substrates and low (<5°C) cross-wafer epitaxial reactor temperature variation. Specular epitaxial layer morphology was obtained, with morphological defect densities consistent with projected 5x5 mm die yields as high as 80% and surface roughness, Ra, of 0.3 nm. Intrawafer thickness uniformity is good, averaging only 1.6% and within a run wafer-to-wafer thickness variation is 2.7%. N-type background doping densities less that 1E14 cm-3 have been measured by CV. Doping uniformity and wafer-to-wafer variation currently average ~12% requiring further improvement. The first 100 m thick 150-mm diameter epitaxial growths are reported.

Abstract: The development of SiC bulk and epitaxial materials is reviewed with an emphasis on epitaxial growth using high-throughput, multi-wafer, vapor phase epitaxial (VPE) warm-wall planetary reactors. It will be shown how the recent emergence of low-cost high-quality 100-mm diameter epitaxial SiC wafers is enabling the economical production of advanced wide-bandgap Power–Switching devices.