Papers by Keyword: Wedged-Ring Joint Structure

Abstract: Finite element method and optimization method are two major ones in engineering analysis. The optimization of a wedged-ring joint structure can be performed by using these two methods unitedly. The response surface design method was employed to determine the combination of geometrical parameters to be designed of the wedged-ring joint structure. The stress of the wedged-ring joint structure which has the different geometrical parameters was numerically simulated and analyzed by using engineering software ANSYS. The optimized geometrical parameters of the wedged-ring structure were obtained by using MATLAB multi-objective optimization method. The results show that the maximum stress and the mass of the optimized wedged-ring structure decrease 13.6% and 12.5%, respectively.

Abstract: The effect of geometric clearances on the stress and deformation distributions of a wedged-ring joint structure is studied, five cases of dimensional tolerance of each contact surface, i.e., the maximum, minimum, mean of maximum and minimum, mean of maximum and mean, and mean of minimum and mean are investigated, and the probable states that the wedged-rings attach with the upper cylinder or attach with the lower cylinder radially in the assembly process are considered as well. The results of finite element numerical simulations indicate that in the design tolerance zone, the effects of geometric clearances between contact surfaces on the displacement and stress distributions of the structural components are weak. Only when the wedged-rings attach tightly with the upper cylinder or with the lower cylinder, the displacement and stress distributions in the joint of the structure occur a dramatic variation, and the assembly processing measure making the wedged-rings attaching tightly with the lower cylinder can be adopted to effectively decrease the stresses and deformations in the joint of the structure.