Research on the Plunge Milling Techniques for Open Blisks

Chen Wei Shan; Ding Hua Zhang; Jun Xue Ren; Chuang Guo Hu

doi:10.4028/www.scientific.net/MSF.532-533.193

Paper Titles

Analysis of Disassembled Module with Damage Model for Recycling
p.177

MEMS R&D Trends
p.181

Research on Mechanism of Electrochemical Mechanical Finishing
p.185

Arc Envelope Grinding of Non-Axisymmetric Aspheric Surface Using Equal-Envelope Height
p.189

Research on the Plunge Milling Techniques for Open Blisks
p.193

The Study of Tool Wear and Breakage Based on the Characteristic Analysis of Acoustic Spectrum
p.197

Fabrication and Characterization of HA/CNT Bioceramics
p.201

Research on Stress and Strain Distribution during Multi-Pass Conventional Spinning under Different Roller Motion Modes
p.205

Research on Influence of the Material Anisotropy to the Surface Quality during SPDT Machining of Crystal KDP
p.209

HomeMaterials Science ForumMaterials Science Forum Vols. 532-533Research on the Plunge Milling Techniques for Open...

Research on the Plunge Milling Techniques for Open Blisks

Abstract:

In order to improve the efficiency and quality in rough milling for open blisks, the plunge milling strategy is a good choice instead of the traditional 5-axis point milling and flank milling for deep and narrow channels machining. Theory and procedures of using a ruled surface to approximate a freeform surface are presented based on the theory of minimum area. The plunge milling strategy is discussed and developed for open blisks. And the NC programs of plunge milling is further developed and verified based on the UG software. At the end, the open blisk test piece was machined by plunge milling. The result reveals that high-speed plunge milling has increased efficiency greatly in the open blisks rough milling than the traditional methods.