Paper Titles
Study on Technology of Micro-EDM with Lower Working Voltage
p.225
Research on a Novel Testing Way for Collective Short Cracks by Industrial CT
p.229
Modeling of Back Pressure Distribution on the Wafer Loaded in a Multi-Zone Carrier in Chemical Mechanical Polishing
p.233
Study on Process of Planing Forming of Plate Fin Heat Sinks
p.237
Study on Surface Integrity of an Ultra-High Strength Alloy in HSC Process
p.241
Study on the Multi-Phase and Multi-Scale Nanocomposite Ceramic Tool Material
p.245
Deposition and Characterization of Ultra-Smooth Nanocrystalline Diamond Films Using a Graphite-Grid Assisted Hot Filament CVD Method
p.249
Research on EDC Special Pulse Generator and Its Experiments
p.253
Study on Effects of the Feed on AFM-Based Nanomachining Process
p.257

Study on Surface Integrity of an Ultra-High Strength Alloy in HSC Process

Article Preview

Abstract:

Aiming to study the surface integrity of an ultra-high strength alloy in high speed milling process, 2K factorial design experiments were conducted to explore the effects of cutting parameters, such as cutting velocity, feed rate and depth of cut, on microstructure, microhardness and residual stress in the sub-surface layer. The following conclusions could be drawn from this paper within the range of cutting conditions: The cutting parameters could significantly influence the microstructure and microhardness in the surface and sub-surface layers, and the original fine martensite of the surface and sub-surface layer might be transformed into the over-tempered martensite, under-tempered martensite, secondary troostite, and tempered sorbite; Compressive residual stress distributions with different maximum stress values in the sub-surface layer of machined surfaces could emerge in high speed cutting process; the properly arranged cutting condition could achieve ideal surface characteristics and surface integrity.

You might also be interested in these eBooks
Advances in Materials Manufacturing Science and Technology II View Preview

Info:

Periodical:

Materials Science Forum (Volumes 532-533)

Pages:

241-244

DOI:

https://doi.org/10.4028/www.scientific.net/MSF.532-533.241

Citation:

Cite this paper

Online since:

December 2006

Authors:

Zhen Hai Long, Xi Bin Wang, Wen Xiang Zhao

Keywords:

Difficult-to-Cut Material, Microstructure, Residual Stress, Surface Modification, Surface Quality

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

© 2006 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

References

[1] S. Tlusty: J. of Manufact. Sci. & Eng., ASME, Vol. 119 (1997) No. 5, pp.664-666.

Google Scholar

[2] M. Field, W. P. Koster and J. B. Kohls: Technical Report AFML-TR-70-11, Air Force Material Laboratory, MATF, Wright-Patterson Air Force Base, Ohio, U.S.A. (1970).

Google Scholar

[3] T. A Harris: Rolling Bearing Analysis (Wiley, New York 1991).

Google Scholar

[4] S. Agha, and C. R. Liu: Wear, Vol. 244 (2000), pp.52-59.

Google Scholar

[5] B.J. Griffiths and D.C. Furze: ASME J. Eng. Ind., Vol. 109, pp.338-342.

Google Scholar

[6] M.C. Shaw: Metal Cutting Principles (Oxford Science Publications, 1989). (a) vc=157 m/min (b) vc=314 m/min Fig. 5 Residual stress distribution achieved at different cutting conditions (fz =0. 1 mm/z; ap=0. 8 mm).

Google Scholar