Papers by Author: M. Guziewicz

Abstract: In this article, an influence of nitrogen implantation dosage on SiC MOS structure is analyzed using wide range of nitrogen implantation dose (between ~1013 – 1016). Authors analyzed electrical and material properties of investigated samples using C-V, I-V measurements, Raman spectroscopy, and XPS profiling. It has been shown that surface state trap density is directly connected to implantation damage and thus implantation conditions. Using research results a trap origin at given energy can be concluded.

Abstract: In this work the electrical properties of Ni and Ni₂Si contacts on n-type 4H-SiC were correlated to the strong structural changes at the contact/SiC interface upon annealing. We can conclude that only δ-Ni₂Si grains play a main role in determining electrical transport properties of the Ni-based ohmic contacts to n-SiC. It is presumed that a recrystallization and texturization of δ-Ni₂Si phase on (0001)SiC-surface during high temperature annealing (> 900°C) contributes to the change of barrier heights, as well as specific contact resistance of contacts.

Abstract: ZnO as well as SiC are wide bangap materials with prospective electronic applications. Very good lattice matching of the materials allowed formation a n-ZnO/p-SiC heteroepitaxial junction. The n˗ZnO film was epitaxially grown onto the p-SiC substrate using the atomic layer deposition method. The fabricated p-n diode was studied by I-V and C-V characteristics as well as by impedance spectroscopy. The diode shows a high rectifying ratio of 10⁷ and an ideality factor of 1.21.

Abstract: The stability of Au wire connections to n-SiC/Ti ohmic contacts and to n-SiC/Ni ohmic contacts with top Au or Pt layers has been investigated. Long-term tests of the connections are performed in air at 400oC. Evaluation of electrical parameters, morphology and structure of the metallization as well as the strength of Au joint show stable Au wire bonds to the metallization with Ti-ohmic contacts.

Abstract: The reliability of Ni2Si/n-SiC ohmic contacts with Au overlayer either without or with Ta-Si-N diffusion barrier was investigated after long-time aging in air at 400oC and rapid thermal annealing in Ar up to 800oC. It is shown that aging of the Au/Ni2Si/n-SiC contacts in air at 400oC resulted in complete degradation due to both oxygen penetration and interdiffusion/reaction processes. In contrast, only a small change in properties was detected on the contacts annealed in Ar at 800°C. The stability of both electrical and structural properties of Au/TaSiN/Ni2Si/n-SiC thermally stressed contacts at different conditions points out their superior thermal stability.