Search results

Cure kinetics and thermal property of UV-curable polyester nanocomposites coating modified with MAP-POSS Jungang Gaoa, Beibei Sunb, Xing Lic College of Chemistry and Environmental Science, Hebei University, Baoding 071002 P.
USA), 29Si,NMR, 1H NMR (400 MHz, Bruker, Switzerland) and high Performance Liquid Chromatography-mass spectrometer (LC/MSD, 1100 type, Agilent, USA) were used for the determination of the components and the detailed structure of MAP-POSS.

The XRD results are presented in Fig. 5 for the raw sample (a) and modified sample (b) products.XRD spectra can display the changes in the crystallinity and structure of the samples after the acetylation.
N.Cheng: Green Chemistry, Vol.9 (2007) p. 85-89.

Wright1,d 1 School of Chemistry, University of Birmingham, Edgbaston, B15 2TT, U.K. 2 Faculty of Dentistry, McGill University, Montreal, Quebec, Canada 3 Smith and Nephew Research Centre, Heslington, York, UK a sxa341@bham.ac.uk, bjake.barralet@mcgill.ca, cd.farrar@smith-nephew.co.uk, d a.j.wright@bham.ac.uk Keywords: amorphous calcium carbonate, amorphous basic calcium carbonate.
Whether this is as a coating or incorporated into the bulk structure is as yet unknown but further detailed analysis is being performed to determine this and provide an improved understanding of the mechanism involved.

Flaky and Porous Rod-like MgO Powders Prepared by Molten Salt Synthesis Jianqi Suna, Hao Chenb, Fei Caoc, and Qinghua Hud Institute of Applied Chemistry, Jiujiang University, Jiujiang, Jiangxi, 332005, China asunjianqi01@sina.com, bchenhao7011@yahoo.com.cn, cjjyz2001@163.com, dqinghuahuiceberg@yahoo.com.cn Keywords: Molten salt synthesis, Flaky, Porous Rod-like, MgO powder Abstract.
SEM image of porous rods of MgO obtained by decomposition of fibrous Mg(OH)2 calcined at 600 ℃ was shown in Fig. 7, which indicated this MgO powder had a porous rod-like structure with diameter between 20 nm and 80 nm and length to width ratio between 40 to 100.

In contrast with the CMOR of samples before thermal shock test, CMORTS obviously decreased due to resin carbon network structure was destroyed after thermal shock treatment.
References [1] Guoqi Liu, Jinsong Yang, Hongxia Li(in Chinese): Refractories Vol. 45 (2011), p. 223 [2] Silva, P.C.; Figueiredo,J.L.: Materials Chemistry and Physics Vol. 72 (2001),p. 326 [3] McMahon,G.

Adsorption of Zn(II) in Aqueous Solutions by Kaolin Junjin Chen, Guoxiang Pan*, Yanfei Yu (Department of Chemistry, Huzhou Teachers College, Huzhou 313000, P.R.
Compared with other methods, adsorption method has many advantages, such as low cost, simple equipment, and no secondary pollution.[3-4] Kaolin is a common clay mineral, which has a 1:1 layered structure of silicate minerals by the silicate layer and the layer of aluminum octahedral shared oxygen atoms.

Design and Synthesis of Fluorescent Betahistine Conjugates with Unique Imaging Property Qiuyan Qin, Yiping Qian*, Ziyu Wang, Xiaolin Fan* Key laboratory of organo-pharmaceutic chemistry of jiangxi province, Gannan Normal University 341000, Ganzhou.
Furthermore, the chemical structure of 1 was confirmed by 1H NMR, 13C NMR and LC-MS spectra.

In these processes, plenty of conditions may have an impact on the structure and adsorption capacity, including addition of oxidant, Li/Mn ratio of raw materials, heating temperature and time, holding temperature and time, granulation method, eluent concentration, adsorption cycle times, precision of temperature control, etc[4].
References [1] Ting Chen, Shuyi Yan, Zihua Kang: Jounral of Salt and Chemical Industry, Vol. 36 (2007), p. 19 (In Chinese) [2] Kelleman D G, Gorshkov V S: Russian Journal of Electrochemisty, Vol. 37 (2001), p. 1227 [3] Koyanaka H, Matsubaya O, Koyanaka Y, et al: Journal of Electroanalytical Chemistry, Vol. 559 (2003), p. 77 [4] Chitrakar R, Kanoh H, Miyai Y, et a1: Ind Eng Chem Res, Vol. 40 (2001), p. 2054 [5] Kaitai Fang, Changxing Ma: Orthogonal and Uniform Experimental Design (Science Press, CHN 2001)

Montedoro, Relationships between the volatile compounds evaluated by solid phase microextraction and the thermal treatment of tomato juice: optimization of the blanching parameters, Food Chemistry. 71 (2000) 407-15
Risueno, Effects of blanching and freezing on the structure of carrots cells and their implications for food processing, J Sci Food Agr. 77 (1998) 223-9

Synthesis of Carbon Nanotubes from Polycyclic Compounds by CVD Method Koji Yamada, Kentaro Abe, Masafumi Mikami, Morihiro Saito, Jun Kuwano Department of Industrial Chemistry, Faculty of Engineering, Tokyo University of Science, 12-1 Ichgayahunagawara-cho, Shinjuku-ku, Tokyo 162-0826, Japan Keywords: Carbon nanotube, Chemical vapor deposition, Camphor, Highly aligned, MWCNT ABSTRACT Multi-walled carbon nanotubes (MWCNTs) were synthesized from camphor by a chemical vapor deposition (CVD) method in a range of 750-900�.
There is now enhanced interest in producing CNTs with desired properties by controlling their morphology and structures sophisticatedly.