Search results

So in theory, the wear resistance of sample 3 is better than that of sample 1 and sample 2, this conclusion is identical with the follow experiment data. 1-Cr2Ni3 2-Ni17W3 3-Cr4Ni15W 4-CaF2 5-Co6W6C 6-Ti8C Fig.2 XRD patterns of the laser cladded coatings Fig.3 shows the distribution of micro-hardness along the depth of cladded layers.
This indicated that the formation of CaF2 in the cladded layers had given full scope to wear-resistant and attrition reduction, moreover, with the content of CaF2 in cladding materials increased, the abrasion loss of sample would reduce.

With a customized frame number of 5,000, there would be also 5,000 data measuring points in the system.
Tridimensional Simulated Assembly for Outward Planetary Pin-cycloid Gears Tridimensional assembly of the established produces, for parts and entire device, can be simulated in a computer following their assembly relations, which is known as “virtual assembly” and based on which, through access to the functions that the application software possesses, the dynamic and static interference checkup among the parts can be conducted, Once any unrational designing point is identified, the drawing can be adjusted and revised, thus to shorten the manufacture and assembly time, reduce the product assembly cost and eventually upgrade the designing quality. 2.1 Determination of Assembly Level The reduction gear for general body assembly is composed of several major subassembly bodies and parts, and then a subassembly body comprises several parts and the next level of subassembly in cycles.

A typical impact-vibration testing system includes vibration sensors, signal conditioners, an impactor and a data acquisition card.
This reduction make it possible to redesign the blades to put more materials to the blade tip to increase the capacity of the small scale HAWT.

VALENCE BAND CONDUCTION BAND CHARGES RECOMBINATION e_ O2 PHOTO-REDUCTION O2.- SUN λ≥EgE h+ OH_ OH.
Ref. data, 17 (1988) 513-886

Residual stresses were evaluated using this data.
Consequently, to not exceed the admissible anode heating ∆T during cold rolling, ≅ 30°C, total reduction r do not surpass 50%, obtained from Eq. 1[5], where the heat looses by convection during this process is almost zero

The theoretical phase curve is obtained by the least-squares method of the obtained data.
Takahashi: Reduction of Speckle Noise Effect by Divided Holograms, Proceedings of 12th International Conference on Experimental Mechanics, ICEM12, (2004), p. 554-555.

At each different test with varying loads the frictional forces were measured using load cell and indicator with a data acquisition system.
The weight reduction was mostly due to the loss of impregnated oils in pores of the bearing.

At present, many synthesis routes were explored to synthesize core-shell nanocomposite, such as vapour deposition, plasma-assisted technique, chemical reduction and self-assembly [4-6].
The monoclinic copper oxide phase obtained was in good agreement with result reported by Wu et.al [11] and standard data (JCPDS 5-0661).

There is slight difference between these numerical approaches and the experimental data.
Fig. 3(b) shows that the COP reduction due to increase in condenser temperature of EERC is lower than that of the standard cycle.

The step angle of stepper motor is 0.36° and the single-pulse step is 0.0000067° through 5400 reduction ratio.
“dsPIC30F6011A/6012A/6013A/6014A data sheet,” 2005