Search results

For so the pigment grain and oil emulsification, wet before catharsis also join the clean agent.
Anionic surfactant rarely used as deinking chemicals, because it can form a large number of stable foam, and no selectivity.

Titanium and vanadium finished the grains and improve the mechanical characteristics.
Borsos, Experimental and theoretical aspects of aluminum expanding laser plasma, Japanese Journal of Applied Physics, 48, issue 6 (2009) article number 066001

The next step is rolling of the slabs at temperature about 1250°C to refine its microstructure – austenitic grains.
Values in the brackets show numbers of imprints in corresponding areas on the other side of welded joint.

Phosphorite ores in Yunnan is a kind of special medium and low grade phosphate rock,because of its unique dissemination characteristics,we needs to be well controlled mineral particle size so that a well monomer dissociation of the phosphate rock particles,but too small particle size of grinding may lead to pulverization for a large number of phosphorus ore,therefore it will causes a waste of resources,so choose the appropriate fine grinding medium is a feasible solution to solve this problem, it will not only improve the grinding efficiency,but also the grinding product characteristics.
Grinding tests If The phosphorite in Yunnan is unique low grade,the former study found that phosphate rock is mainly a false oolitic structure output in the ore,its main granularity ranges from 0.05 to 0.3mm,which belongs to the fine-grained dissemination.In order to make the ore recovered as completely s possible,it is essential to control the product particle size in 200~400mesh.And there are three ways need to do,firstly,increase this part of level ratio,which strictly requires the grinding medium,a strong impact shoule be give up;secondly,strengthen the grinding effect of grinding medium,to decrease as far as possible pulverization level rate under the premise of useful minerals and gangue minerals separated; thirdly,guarantee a high monomer dissociation.the low grade collophane mechanical properties results is shown in Table 1: Table 1.

Introduction Recently there have rather actively been studied metastable condensed systems possessing a number of new physical-and-mechanical properties differing from the properties of equilibrium systems.
A special place among them is taken by nanostructured materials whose volume significant part make grains boundaries.

It’s generally believed that WPC tool wear is mainly due to mechanical abrasive grain wear and chemical wear.
For high speed milling which produces a large number of chips, high coefficient of friction between the chip and tool and structure of cutting tool may lead to obstructed chip.

Higher shear stress value is needed to initiate shearing with the increase in slurry concentration due to the presence of relatively more numbers of solid particles.
Yang, Experimental study on correlativity between rheological parameters and grain grading of coal gauge backfill slurry, J.

Using a condition of balance of chemical potentials between a crystal grain of radius r, representing firm solution A in B, surrounded by its own melt in view of surface pressure [15], the equality of chemical potentials looks like: , (1) Using (1) for temperature of CM for nanoparticles it is possible to receive: , (2) And for nanofilms: , (3) Where - chemical potential; σ - interphase energy; Ω - atomic volume, λ - heat of CM.
It is necessary to note, that in a number of works [16-21] influence of pressure on phase transitions in nano-objects immersed in the matrix of the second phase was studied.

The mixture of α and b β phases was arranged like a weave pattern (Widmanstatten structure) on the primary β grain boundaries.
In the Ti-6Al-7Nb alloy, the number of the α phase decreased after solution treatment, and therefore the hardness value decreased.

The sand grain roughness height for the iced surface was calculated with an empirical NASA correlation described by Shin et al. [8, 9].
(2) where, is the water volume fraction, is the droplet velocity, is the droplet drag coefficient and Fr is the Froude number.