Search results

Results and Discussion After measuring the dimensions and testing each of the parts that were created from various techniques of rapid tooling, the data was placed into tables to be analyzed.
With more testing and time, this will become a new source of conventional tooling due to the reduction of time, cost, and weight.

The green sample with dimensions 10×10×60 mm3 was initially pre-sintered in a vacuum furnace at 1400oC for 2h to increase its strength through porosity reduction (~40%) prior to the neutron study.
The neutron diffraction data collection was performed using a medium resolution powder diffractometer (MRPD) located at the Australian Nuclear Science and Technology Organisation (ANSTO) in Lucas Heights, NSW.

The application of GLARE laminates in A380 has allowed significant weight reduction of 800kg.
This paper focused on the experimental studies of GLARE bolted joint and revealed the influence of geometric parameters, ply orientation and tightening torque on the GLARE bolted joint preliminary, thus providing data support for the design of GLARE joint.

But with the reduction of blank-hold force, wrinkling trend increased on local part.
Through measuring three sets of data, we get trend which maximum springback quantity in Z direction change with blank-hold force, as shown in figure 6.

Three concentrated loads were applied throughout the blade to extract all displacement, stiffness-strength data.
E-glass/epoxy demonstrated excellent strength and weight reduction with few lay-up changes.

These images clearly indicate an improvement in quality by a reduction in the occurrence of large cracks in the through and rib sections of the casting, comparing injection profile B (Figs. 3b & 3d) to injection profile A (Figs. 3a & 3c).
Modelling and simulation of die filling would be useful but the lack of shear rate dependence on temperature data of semi-solid Al-Zn-Mg-Cu precludes its usefulness.

Statistical analysis of quantitative data to ± s, the number of groups were compared by analysis of variance, comparison of rates with chi-square test.
Because metabolic syndrome is not exactly the same as a single disease such as diabetes, while in the presence of multiple risk factors, should be integrated application of antihypertensive, lipid-lowering, hypoglycemic, and weight reduction programs.

Rotter type A has its greatest reduction to the carrying capacity of the cylinders.
Meanwhile, the measured data is close to halfway between Rotter type A and B [6].

However, only a few data of the oxidation behavior of the conventional Co-Cr alloy is available.
In contrast with former published results [8], the maximum reduction didn’t achieve because the Cr content content was not enough to support the growth of a dense, stable Cr2O3 layer.

At present these resources are most used for refractory raw material, but the records which short mullite fibers are manufactured by the andalusite mineral resources have not been seen in the literature data.
The value of interplanar spacing lessens with reduction of lattice parameter [7], in other words, the lattice parameter of mullite is the smallest under 1450˚C.