Search results

During the last years a reduction of the off-cut has been reconsidered mainly to reduce the crystal waste when slicing wafers with large diameter and due to the improvement of the crystal quality, polishing of the wafers and growth process.
Higher growth rates were reported by using trichlorosilane as silicon precursor at a high growth rate, but no surface morphology data was available [3].

One-way analysis of variance (ANOVA) was conducted to analyze the data and the mean comparisons were run by Duncan’s multiple range tests at P < 0.05.
The significant reduction of the WVP the film materials when it contained nano-SiO2 could be explained as that the nano-SiO2 particles had a low water solubility compared with the gelatin and chitosan, and the pathway of water vapor were tortuous caused by SiO2 nano-particles.

(2) Under different levels the creep compliances meet the following equivalent relation by reduction time
(3) Therefore, the long-term creep properties under low stress of non-linear viscoelastic material can be achieved by short-term creep data under high stress.

We can determine the offset distance d between the underlying mould cavity surface and the cooling layout from the theoretical calculation or practical data[5].
The range of the average temperature (between minimum and maximum temperatures) of VRCCC (48.1 o C) is kept narrower than the CCC (59.68 o C) one, a reduction of 24%.

According to the data obtained from mining company it is expected that horizontal terrain deformation is , at first the subsoil is compressed and then expanded, each phase will be lasting 16 months.
Manasek, Building structures in danger of flooding, in proceedings of IABSE Conference on Role of Structural engineers towards reduction of poverty, New Delhi, India, 2005 [3] O.

An increment of 10 kN is applied to the composite beam so that a uniform data and gradual failure of the specimen can be monitored.
The failure condition is considered to have reached when an abrupt or significantly large reduction in the applied load.

Rare thermodynamic data exists to fully formulate these models.
Except for oxygen and aluminum, the other metals provide a reduction on temperature transition, mainly V that can reduce until room temperature if added in sufficient concentration.

Therefore, when the wave impedance of explosive and rock has appropriate difference, the seismic reduction effect can be achieved
Data from gap charge studying shows that peak pressure of coupling charge is greater than gap charge.

In the same time the intensity of the Ir peaks fall near to zero (about 15 % of the sample, according to the Fullprof data).
Once the IrAl structure is obtained the peaks became broader with continuation of milling indicating the mean grain size reduction of the powders and the introduction of strains.

However, there is a tendency of Nb content reduction in NiTi SAs [9], with keeping large hysteresis by inducing distortions in crystal lattice.
Transformation temperatures The resistivity of the processed NiTi-Nb alloy variation with temperature at heating and cooling (Fig. 4) gives informative data on the transformation temperatures: As = 99 0C; Af = 131 0C; Ms = 73 0C; Mf = 47 0C.