Search results

The weight of the lower beam is selected as the objective function, because it accounts for a large percentage for the total weight of the hydraulic press and the weight reduction of the lower beam can reduce the total weight and cost of the hydraulic press.
This need combine with VC++ and APDL, ANSYS is called as a subprogram of VC++ and the data is transmitted between ANSYS and VC++.

Currently thermal oxides grown or annealed in NO (or N2O) are the mainstream dielectrics but more reduction in interface trap density is needed [2].
This is further revealed in Fig. 2 which show the interface trap density extracted from CV dispersion data at room temperature for AlN as well as the reference SiO2 MIS devices.

When the load changes, the output of the power system voltage is stable, and the effect of energy conservation and emissions reduction is obvious, thus it brings great economic benefits to the enterprise.
References [1] Ke Z W,Feng Q X.Design of the Multi-functional Data Acquisition Module Based onMulti-taskingOperating Mode of MCU[J].Process automation instrumentation.2014, 35(1): 84-87

The replacement of OH groups was evidenced by the reduction of the bands around 3300 cm -1 corresponding to OH stretching of cellulose.
MARK, Polymer Data Handbook, Oxford University Press Inc (1999)

This means that Au has the highest possibility of reduction.
This result was strongly supported by the PL measurement data showing that the PL intensity of the SCM ZnO powder was about 3 fold higher than that of the commercial state of the art TiO2 powder.

As seen from the above, so far there is a difficulty with obtaining a crack-free coating; therefore an urgent problem is to obtain new experimental data in order to reduce cracking during the laser cladding.
The maximum effect (reduction in the number of cracks in 2-3 times) arises at power density (2-3h104 W/cm2) and cladding rate (0.5-1m / min) (Fig. 2). .

., the FRP confinement in the current circumstance), the ACI design code proposed the following model to predict the axial capacity (2) where f is the strength reduction factor and a value of 0.7 is proposed according to ACI 318-05 [5].
(9) where (10) in which R is the radius of the column; eru is the design FRP hoop rupture strain and can be calculated by 0.5 ffu / Ef in the case of absent test data; and fc,k is the characteristic strength of unconfined concrete.

Especially today, it has proposed energy conservation and emission reduction, realizing the low carbon production.
Fig. 1 Structure diagram of the inside and outside tube differential pressure flowmeter Experiment Operating Condition In order to ensure scientificity and reliability of the experiments data, all the wet gas experiments of the new designed flowmeter are accomplished on the standard experimental device of variable pressure middle pressure wet gas flow, in wet gas flow laboratory, at Electrical and Automation Engineering College of Tianjin University [9].

Cycloid drives are compact, lightweight devices capable of producing high reduction ratio, high efficiency, high accuracy in single stage and long operating life at the same time.
For single pitch point drive with the similar initial data: r2= 39 mm, Z = 13, rp= 6.5 mm, χ = 1.35 forces will be Fv= 1739 N, Fk= 1739 N, Fc= 0 N.

Clearance is calculated according to the relevant provisions of GL specification [3], which is the minimum distance of all conditions calculated must be greater than 30% of the stationary Blades distance. 3) Load: differences due to differences in the type of each Blades airfoil cross section and the quality of data, the unit can cause the stiffness distribution load generating large differences shown in Figure 5.
Thrust reduction, refers to the motor speed before the wind has not yet reached the rated speed began to make the pitch control action.