Search results

Yan, Anomalous phase transformation in magnetostrictive Fe81Ga19 alloy, Journal of Magnetism and Magnetic Materials 322, 19 (2010) 2882-2887
Fang, High damping in Fe-Ga-La alloys: Phenomenological model for magneto-mechanical hysteresis damping and experiment, Journal of Materials Science & Technology 72 (2021) 69-80
Lograsso, Magnetoelasticity of Fe–Ga and Fe–Al alloys, Journal of Magnetism and Magnetic Materials 226–230, Part 1 (2001) 948-949
Materials. 2023; 16(6):2365
Li, In vitro corrosion properties and cytocompatibility of Fe-Ga alloys as potential biodegradable metallic materials, Materials Science and Engineering: C 71 (2017) 60-66

Research of Waste Recycling Natural Fiber Materials at Green Roof Chiou-Chuan Chen1 Chuan-Chen Lee2 1,2:Assistant Professor, Chung Chou University of Science and Technology, Department of Landscape Architecture,No.6,Lane2,Sec.3,Shanjiao Rd.
Sowing 3.Results and Discussion (1)Test materials screening lightweight,saturated moisture content,low-cost[4,5,6,7] This experiment studies the use of 10 kinds of organic fiber cross mixing, 91 group compound formulated proportional combination of all test materials after drying, dry weight (light ; 803g↓), saturated moisture content (water retention rate; 226%↑) , making the media materials fee calculation (low-cost;＄1.3 USD).
All of the test materials through quantitative data analysis and comparison of the 5 groups selected of material that suits the media light, saturated moisture content, low-cost.
&Lee,S.H., Research of green roof and façade vegetation reduce the heat efficiency (I) Journal of Health and Care Science Vol.1 N0.2 p88-103.,(2012),Taiwan(R.O.C
[7] Sendo, T., Kanechi, M., Uno, Y. and Noboru, I., “Evaluation of Growth and GreenCoverage of Ten Ornamental Species for Planting as Urban Rooftop Greening”, Journal of the Japanese Society for Horticultural Science, 79 (1):69-76.( 2010)

The present study has been aimed to combine the advantages of the two single-phase materials, Al2O3 and ZrO2 while avoiding their disadvantages, by producing a mixed ceramic.
Introduction Alumina and zirconia ceramics have been successfully used as materials for joint endoprostheses.
The coupling of ZrO2 with Al2O3 components, used with varied results, is under debate, too. [3] Material and Methods The present study has been aimed at combining the advantages of the two single-phase materials, Al2O3 and ZrO2 while avoiding their disadvantages, by producing a mixed ceramic.
This high-strength, thermodynamically stable material is necessary for the manufacture of products that have so far been the domain of metallic materials alone.
DKG 80; 2003; No.4; S.E 27-34 [7] Lawson, Gill, Dransfield: Hydrothermal and Corrosive Degradation of Y-TZP; Key Engineering Materials Vol. 113; 1996; S. 207-214 [8] M.Hirano, H.Inada: Hydrothermal stability of yttria- and ceria.doped tetragonal zirconia-alumina composites; Journal of Material Science 26; 1991; S. 5047-5052 [9] J.J.Swab:Low temperature degradation of Y-TZP materials; Journal of Material Science 26; 1991; S.6706 [10] ISO standard 7206/2: Implants for surgery - Partial and total hip joint prostheses Part 2: Articulating surfaces made of metallic, ceramic and plastics materials; International Organization for Standardization; 1996

Optical microscope and Electron microscopy were employed to evaluate the properties and morphology of the materials.
Introduction Phase change materials (PCMs) can store and release energy during phase change processes [1,2].
Microencapsulated phase change materials (MPCMs) not only have the ability of phase change from solid-liquid to presolid-solid in the meantime avoiding the influence of outside moisture, oxygen and other factors, but also can improve the stability of phase change materials.
Experimental (1) Materials and experimental equipment Low melt-point paraffin wax (Tsinghua university CP) was employed as core material.
Chinese Journal of Pesticide Science, Vol. 8 (2006), p. 152

One of the modern trends in design focusing on sustainable, energy efficient and environmentally friendly architecture creates a demand for new materials and products that reflect modern achievements in the field of building materials science.
Tarskaya-Lapteva, Chrysotile-cement building materials.
Rashad, A comprehensive overview about recycling rubber as fine aggregate replacement in traditional cementitious materials, International Journal of Sustainable Built Environment. 5 (2016) 46–82
Abdel-Hameed, Mechanical, fracture, and microstructural investigations of rubber concrete, Journal of Materials in Civil Engineering, 20 (2008) 640–649
Veiga, Mortars made with fine granulate from shredded tires, Journal of Materials in Civil Engineering. 25(2013) 519–529.

Applying Study on the Bayer Red Mud as Fast Building Dam Materials Donglan Luo Hydraulic Engineering and ecology of department, Nanchang Institute of Technology, Nanchang Jiangxi , 330099, China lan_127@163.com Keywords: Bayer Red Mud, The Technology of “Three-dimensional Seepage Drainage Stack”, Tailing Dam, Strength Indices.
The way of “three-dimensional seepage drainage stack” makes good use of waste materials, reduces the yard space, saves the red mud rolling or compaction equipment, economizes the constructed cost of the dam.
Utilizing waste materials and reducing the cost of building dam come true, if bayer red mud are used as building materials of dam.
[2] Yinghui Qiao: submitted to Journal of light metal, 2004, in China
[7] Mingyang Li: submitted to Journal of Guizhou University of Technology (NATURAL SCIENCE EDITION) 2006, in China

Journal of Materials Science, 2002. 37(8): p. 1683-1692
Journal of Materials and Environmental Science, 2015. 6(4): p. 902-917
Journal of Composite Materials, 2016. 50(2): p. 257-267
Usak University Journal of Material Sciences, 2014. 3(1): p. 135
Journal of Thermoplastic Composite Materials, 2012. 25(1): p. 45-58

GTA Welding of Copper Thick Plates by Using ERCuTi Welding Materials Y.N.
Ho.: Materials Science and Engineering A Vol. 293 (2001), P. 7 [7] H.L.
Ho.: Materials Science and Engineering A Vol. 279 (2000), P. 254 [8] B.
Chinta Babu: Materials Science and Engineering A Vol. 491 (2008), P. 331 [10] S.
Balasubramanian: Journal of Materials Science Vol. 32 (1997), P. 3375

(ii) Recycling of used comfort materials?
Databases searched are SAGE Journals, Science Direct, Springer Link and Taylor Francis Online.
In the product design stage, bio-materials, electronic materials and smart materials were used as a method for manufacturing eco-friendly comfort textiles.
However, the journal sources are limited in database of SAGE Journals, Science Direct, Springer Link and Taylor & Francis Online.
; (ii) Recycling of used comfort materials?

Research on Biological Materials by Applied Technology with An Algorithm for Identifying and Counting Cells in Microscopic Particle Image Suiyuan Zhang1,a, Rui Wang2,Xianqiao Chen1, Zewu Jiang3 and Xiang Cai1 1Wuhan University of Technology, School of Computer Science and Technology, Wuhan, Hubei, China 2Wuhan University of Technology, School of Energy and Power Engineering, Wuhan, Hubei, China 3Wuhan University of Technology, School of Logistics Engineering, Wuhan, Hubei, China aa_dayuanzi@163.com Keywords: cell microscopic images ; image edge detection ; particle identification ; Biological Materials ; counting cells Abstract.
Summary As the development as science, we pay more and more attention to the Biological Materials.
Huazhong University of Science and Technology, 2012 [2] Zhong Cai.
Journals of images and graphics, 2005, 10(1): 1-10
Journal of Wuhan University of Technology: Information and Management Engineering Edition, 2005, 27(5): 25-27