Search results

Although only transgranular cracks were found under relatively low pressure, e.g. 30MPa, where reduction in failure strain was not significant, intergranular fracture appeared under higher pressure conditions.
Data, 9 (1980) p.1291. 2.

One of the advantages of this technology is the cost reduction compared with traditional forming processes such as stamping and deep drawing processes because punches or expensive dies are avoided.
This allows for the efficient collection of the necessary data to determine which factors most affect product quality with a minimum amount of experimentation.

The results showed that the sensor exhibited a weak response to dimethoate, malathion, phorate and atrazine, with the reduction of potential significantly less than that for CPF under the same concentration of solution.
Acknowledgment This study was financially supported by the import direction project of Chinese Academy of Sciences (project No: KSCX2-YW-N-035), the plan of science and technology of Liaoning province (project No: 201041501).The authors are highly indebted to colleagues who participated in the fieldwork and data processing.

The uniaxial tensile tests were carried out to determine the tensile properties like yield strength, percentage elongation, ultimate tensile strength and reduction of cross sectional area at room temperature.
[19] American society of testing and materials International E407-07., Standard practices for micro Etching metal and alloys. www.astm.org/ DATA BASE.CART [20] American society of testing and materials International E8-04., Standard test method for Tension testing of metallic materials

Origin data analysis can be used to get the area under the master curve of the stiffness modulus of asphalt.  
Aging effect makes the light weight components and oil in asphalt reduction, reducing the cross-linking between the asphalt and modifiers so that modifiers highlighting asphalt surface, interfacial degradation.

In conventional direct extrusion effective strain is introduced by reduction in the cross sectional area [5].
Information about variables of TES process is necessary to optimize the process but it is very difficult to obtain these data from experiments.

From the result of this research, the best result obtained using DES with a molar ratio of 1: 2 with FFA reduction efficiency of 36.72 %.
Samples (RBO) dissolved with n-hexane were placed in a 1-cm quartz cell cuvette and operated in bandwidth = 1 nm and pitch data = 1 nm and analyzed at a wavelength of 311 nm.

Standardized evaluation is determining the energy need in the building by calculating using standard input data, actual execution of building structures.
In relation to global warming, stress is increasingly put on reduction of emissions of harmful substance emissions into the air, mainly of CO2, i.e. on evaluation of buildings from the point of view of production of these substances.

Due to this, the disadvantage of higher costs for manufacturing of precursor materials and also forming, caused by the high reactivity of the alloying elements Li and Mg, is compensated by the demands of aerospace applications, where even small weight reductions result in high added values.
Because of the non availability of thermo-mechanical data of AA1420* , A356 was used as cast alloy for the simulations.

It should be highlighted that although the wearing process occurred at high temperature, it is not sufficient for recuperation of the material, a reduction in the discordance density, which results in a greater level of resistance in that region.
Another point observed in the data presented in Table 2, is that the Cr3C2NiCr-coated substrate presented greater microhardening than the remaining samples, especially ASTM 178 steel used in the TEP.