Search results

Stacey used a Cauchy mutation for each dimension of position with probability 1/D, where D is the number of dimension.
Under these situations designing a reasonable on-line computer anti-lock system is an alternative to solve the current problem[1].
The software framework of the intelligent locks is shown as Fig.1.
References [1] Olfa Nasaroui, Fabio Gonzdez, Dipankar Dasgupta .The Fuzzv Artificial Immune Svstem: Motivations, basic Concepts and Application to Clustering and Web Profiling[J].Fuzzy Systerm 2002,1(2):711-716
“Optimal training sequences for channel estimation in bidirectional relay networks with multiple antennas,” IEEE Transactions on Communications, vol. 58, no. 2, pp.474-479, 2010.

It exhibit merits such as simple structure, quick response, quiet operation, not affected by electromagnetism and low noise [1-4].
Fig.1 gives the transmission principle of pipe by utilizing bending ultrasonic wave [5-6].
As Fig.1 shows, the materiel moves toward the reverse direction of the bending traveling wave.
References [1] S.
Grate: IEEE Ultrasonic Sympium, vol. 1 (2002), p. 475~479 [6] Takano T and Tomikawa Y: IEICE technical report, vol. 101 (2001), p. 21-26

Operation conditions analysis on solar energy compression-injection secondary refrigeration system Feifei Zhang1, a, Qi Tian1,b,*, Liyuan Yin1,c 1 College of Environmental Science and Engineering, Taiyuan University of Technology, No.79, West Yingze Avenue , Wanbailin District, Taiyuan City, Shanxi Province, 030024, China azhangfei292@163.com, btqfyj@soho.com, cyly0940@link.tyut.edu.cn Keywords: Compression-injection refrigerating system, Generation temperature, Intermediate cooling temperature, Condensation temperature, Evaporation temperature Abstract.
Description of the system The fig. 1 shows: solar energy compression-injection secondary refrigerating system is made up of the subsystem of solar energy injection refrigeration & mechanical compression refrigeration.
Fig.1.
References [1] Zeren,F.
Energy Covers.Manage.38(5)(1997)479-491

As shown in Figure 1: Fig.1 Diagram of the simulation model credibility evaluation system On the same floor indexes, the index will directly affect the credibility of the index.
This example only considers the relationship of the upper and lower layer index and relationship of the bottom index same layer, the bottom index is quantified by 10 points, the weight value according to the analytic hierarchy process is showed in Table 1, we can calculate the credibility of reconnaissance command coordination ability by the following ways： Table 1 The indicators weigh C4 C7 Criteria D1 D2 D3 D4 D5 D6 D7 D8 D9 Weight 0.22 0.19 0.21 0.18 0.20 0.23 0.2 0.23 0.28 Table 2 The consolidated results reliability C1 C2 C3 C4 B1 AHP 8.882 9.160 8.586 8.379 8.767 CEM 8.949 9.093 8.862 8.594 8.931 After 10 exercises and equipment requirements certification, we can obtain the average data table, as shown in Table 2.
References [1] WANG Ying-luo, System Engineering [M].
Research on method of measurement and verification on comprehensive credibility of simulation data [J].Journal of System Engineering, 2008, 08: 479-187 [3] H.Hashim and J.Abdul Manan, Active Anycast Method for server Load Balancing [J], 2008. 9 [4] SUN Ya-feng, WANG Chao-yang, HUANG Zhi-ping.

Introduction Semiconductor nanowires of different materials have been under intense investigation due to their potential as key building blocks for nano-electronic and nano-photonic applications [1-3].
For the PL spectra measurements, the nanowires remaining on the Si substrates were excited with a 750 nm pulsed laser, at a repetition rate of 82 MHz at an average power of 60 mW focused to a 1 mm spot on the nanowires.
Fig.1 X-ray diffraction patterns of InP nanowires grown at 3300C, 3500C and 3700C.
References [1] J.M.
[14] Shuzhen Yu, Guoqing Miaoa, Yixin Jin, Tiemin Zhang, Hang Song, Hong Jiang, Zhiming Li, Dabing Li, Xiaojuan Sun Journal of Alloys and Compounds 479 (2009) 832–834 [15] Jiming Bao,David C.

These peaks located at about 398.68 cm-1, 516.22 cm-1 and 638.04 cm-1 which can be assigned to SnO2 optical phonons.
It is clear that the most intense peak is observed at 638.04cm-1.
References [1] C.
Ramamurthi, Materials Science in Semiconductor Processing, 16 (2013) 427-479
Lett., 26 (7) (2009) 077803-1-077803-4

Until the end of 2005, there have been 479 garbage disposal sites around 661 cities, and the processing is 257,000 tons/day with the disposal rate 51.97%.
The respective proportions of the processing power of landfill, composting and incineration are 85%, 5% and 10% [1].
References [1] China's official statistics of Urban Solid Waste http://www.shjec.cn/new [2] Yuan Hui, Wang Li’ao, Su Fenwei, Hu Gang.

Mendeleev's periodic law Structure of an atom Chemical bond, molecular structure Structure of solids and liquids Regularities in chemical reactions Water and solutions Electrolytes solutions Redox, Fundamentals of electrochemistry Dispersion systems, Colloids Hydrogen Halogens Group VI A Group V A Subgroup IV A General properties of metals IA of the periodic table Complex compounds Group II of the periodic table Group III of the periodic table Groups IVB, VB, VI,B VIIB Group VIIIА of the periodic table Relative max length L Relative relation strength С   Group of concepts 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22     1 Substance ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ 1,00 1,00 2 Atom ♦ ♦ ♦ ♦ ♦ ♦ ♦   ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ 1,00 0,90 3 Energy ♦   ♦ ♦ ♦ ♦ ♦   ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ 1,00 0,86 4 Molecule ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ 1,00 0,82 5 Electron ♦   ♦ ♦ ♦ ♦     ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ ♦ 1,00 0,75 6 Mass ♦   ♦     ♦ ♦   ♦ ♦ ♦ ♦ ♦ ♦ ♦
We calculated the main quantitative characteristics of the interdisciplinary connections [1], which subsequently allowed to establish a hierarchy of physical concepts in the course of chemistry. 1.
For example, the concepts of atom and substances have the same meaning of L = 1.
References [1] Gnitetskaya, T.N.
Tikhonov. - 2nd ed., Stereotype. - M.: High School, 1994.– . 479.

The model is shown in Fig.1.
The properties of geomembrane are shown in Table 1.
Table 1　Properties of geomembrane (20℃) Geomembrane 1% secant modulus (MPa) Strength (MPa) Breaking strain(%) HDPE 484 34.2 820 Testing Equipment and Method.
References [1] Yang Z H, Zen G M, Chen J, et al.
Creep and Stress Relaxation of Geogrids, Geosynthetics International, Vol.4(1997), pp:463-479.

Murasheva 1, E.A.
Fortalnova 1,a, E.D.
Safronenko 1, S.
Fig. 1.
Table 1.