Search results

Fang, European Journal of Inorganic Chemistry, 2008 (2008) 2429 –2436
Chen, The journal of physical chemistry.
Chen, The Journal of Physical Chemistry B, 110 (2006) 25782 – 25790
Lu, Materials Chemistry and Physics, 120 (2010) 23 – 30
Lin, Materials Chemistry and Physics, 133 (2012) 163 – 169.

These kinds of structure can let those compounds possess some special nature, for example catalytic activity, etc.
The purpose of this study is using Fe2(CO)9 examines the removal effect of COS.Aiming at the result analyzing the reasons.And through comparing Fe2(CO)9 examines the removal effect of CS2 with the removal effect of COS.Then use the method of Physical Chemistry, the interaction between Fe2(CO)9 and COS are listed for further study. 2.
Basically maintain the level of 20%~60%.It also did not come to the effect that we expect,even lower than the removal effect of COS.Then eliminate the influence of CO competes.So the condition is important for Fe2(CO)9,which comes to the best removal effect of COS need special conditions.Then through the physical chemistry study the possibility interaction between Fe2(CO)9 and COS. 3.Analyzing of Reaction mechanism According to electronic structure of 18,the structure of Fe2(CO)9 is following: Chart 1 Molecular structure of Fe2(CO)9 Now, according to molecular structure of Fe2(CO)9, the possible interaction between Fe2(CO)9 and COS are listed: The result of the first kind of interaction: (2) The result of the second kind of interaction: (3) The result of the third kind of interaction:
Conclusions In this work, the removal effect of COS over Fe2(CO)9 at atmosphere pressure was invented.The result of the removal effect of COS over Fe2(CO)9 at atmosphere pressure is “not good”.Analyzing the removal effect of CS2 over Fe2(CO)9 at atmosphere pressure is also.Then exclude the influence of the competition of CO.Such is the effect of Fe2(CO)9.According to physical chemistry analyzed,which has three kinds of between Fe2(CO)9 and COS.And these kinds possibility make COS activation absolutely.So Fe2(CO)9 has a good results for the removal of COS,Which play a good removal effect under the special condition.
A new coordination mode for CO synthesis and structure of Cp4Mo2Ni2S2 [J].J AM Chem Soc,1989,111(21);8279-8280

., specific surface area, pore size distribution and surface chemistry, were studied.
The surface organic structures of the bamboo and the activated carbons were studied by Fourier transformed infra-red spectroscopy (470FT-IR, Nicolet Nexus).
In accordance to the classification adopted by the International Union of Pure and Applied Chemistry (IUPAC), pores are classified as micropores (<2nm diameter), mesopores (2-50 nm diameter) and macropores (>50 nm diameter) [16].
These results are in agreement with the surface chemistry of other agricultural by-products such as peach stones and rockroses.
Activated carbon from jackfruit peel waste by H3PO4 chemical activation: Pore structure and surface chemistry characterization.

Photocatalytic Destruction of Methyl Orange by Titanium Dioxide Powder Synthesized by an Oxalate Co-precipitation Method Pusit Pookmanee1,a , Sirion Angkana1,b, and Sukon Phanichphant2,c 1 Department of Chemistry, Faculty of Science, Maejo University, Chiang Mai, Thailand 2 Department of Chemistry, Faculty of Science, Chiang Mai University, Chiang Mai, Thailand a pusit@mju.ac.th, bsirion_angkana@yahoo.com,c sphanichphant@yahoo.com Keywords: Titanium dioxide, co-precipitation method, methylene orange Abstract.
Single phase anatase structure was obtained after calcination at 400 °C.
Multi-phase of anatase and rutile structure was obtained after calcined at 600 and 800 °C.
In the Analytical Chemistry Laboratories it is mainly used as an acid base indicator due to its ability to function as weak acid as the aqueous solution of the dye has a pH value of approximately 6.5 (5 g.L -1, H2O, 20 ◦C) [7].
Confirmation structure of TiO2 powder was obtained by comparison with the Joint Committee on Powder Diffraction Standards (JCPDS) Card File No.21-1272 [11] and 21-1276 [12].

Ab-initio optimized geometer structure of compound V.
Research Paper of Faculty of Chemistry.
Synthesis and characterization of 1,4-diamino-1,4-dicyanocyclohexane dicarboxylic acid, Research Paper of Faculty of Chemistry, NUM. 6 (2006) p. 82
Research Paper of Faculty of Chemistry, NUM. 6 (2006), p. 90
Chemistry, seventh ed., Houghton Mifflin Co, 2007

The control of the interfacial chemistry between a high-k dielectric and III-V materials presents a formidable challenge compared to that surmounted by Si-based technologies.
InP is under consideration for quantum well channel MOS structures in order to serve as a better nMOS channel interface.
Substrates are then analyzed for an assessment of the initial surface chemistry present typically by XPS and electron diffraction (for long range structural order assessment).
The apparatus design enables the study of the effect of single precursor exposures on the surface (viz., half-cycle studies) and thus the resultant interfacial chemistry during film growth, which can be correlated to device behavior. [5] III-Arsenides As noted in a recent review, [5] InxGa1-xAs are now among the most studied interfaces with high-k dielectrics.
The authors acknowledge the support of the Semiconductor Research Corporation Focus Center on Materials Structures and Devices (MSD), the Nanoelectronics Research Initiative (NRI) with the National Institute of Standards and Technology (NIST) through the Midwest Institute for Nanoelectronics Discovery (MIND), and the National Science Foundation (NSF) under ECCS award 0925844.

The internal structure of plane-parallel plates of shungite is studied.
The globular structure is characterized by both types of the distribution of the graphene layers, while the flaky, layered, and film structures exhibit preferred orientation of these layers.
Malcolm (Jr), The Synthesis of Megatubes: New Dimensions in Carbon Materials, Inorganic Chemistry vol. 40, no. 12 (2001) 2751–2755
Kovalevsky, Structural State of Shungite Carbon, Journal of Inorganic Chemistry vol. 39, no. 1 (1994) 28-31
Tupolev, On Fullerene-Like Structures of Shungite, Carbon, Journal of Physical Chemistry vol. 70, no. 1(1996) 107-110,

Progress of Small Molecule Fluorescent Probes for Detection of Thiols Yan GAO College of Chemistry, Chemical Engineering and Materials Science, Shandong Normal University, Jinan 250014, P.R.
Therefore, the quantitative detection of mercapto biomolecules are very important in biochemical and clinical chemistry.
Fig. 1 Structures of Thiol Probes Bearing a Maleimide Group In 2007, Nagano et al. synthesized a thiol fluorescence probe using o-maleimide BODIPY fluorophore [9], in which the fluorescence intensity was again strongly quenched by PET process (Fig. 2) Fig. 2 Structures of Thiol Probes Reported by Nagano et al Based on Cleavage of Sulfonamide and Sulfonate Ester by Thiols In 2005, Maeda et al. synthesized a thiol fluorescence probe based on nucleophilic aromatic substitution [10], as shown in Fig. 3, R=H,CH3.
((Fig. 4) Fig. 4 Structures of Thiol Probes bearing 2,4-dinitrobenzenesulfoyl Moiety Based on Cyclization with Aldehydes It is because that the aldehyde group can react both cysteine and homocysteine, but not with GSH.
Fig. 5 Structures of Thiol Probes Reported by Loh and Chen et al In 2012, Yonn et al. reported a fluorescence probe to detect cysteine based on cyclization with aldehydes [13].

They have already been employed in all areas of chemistry and materials [1-3].
FTIR and XRD were used to analyze the structure of the films.
Characterization of Structure.
Cellulose and chitosan have similar molecular structure, which leads to the analogous structure of blended films in different ratio and show the similar mechanical properties of films.
References [1] Ionic Liquids, Industrial Applications for Green Chemistry, ed.

This result suggests that the FePO4 synthesized by wet chemistry is amorphous and the inorganic component in pollen grains may dissolve during the synthesis.
Zhang, et al: Chemistry of Materials Vol. 19 (2007), p: 2144 [4] S.
Seki, et al: Chemistry of Materials Vol.19 (2007), p: 2389 [6] G.
Lu, et al: Chinese Journal of Chemistry Vol. 26 (2008), p: 467 [10] M.P.
Han, et al: The Journal of Physical Chemistry C Vol.116 (2012), p.10274