Search results

Materials and methods Field sites and material.
Innovation and progress of agricultural water-saving science and technology in China.
Agronomy Journal, Vol.93, No.2 (2001), p. 290-298 [4] Z.B.
Maize Science, Vol.2, No.3 (1994), p. 56-60 (in Chinese) [7] Q.X.
Journal of Triticeae Crops, Vol.24, No.1 (2004), p. 92-94 (in Chinese) [20] S.

Source-separated collection, which means that MSW is first classified as several different parts such as composting material (e.g. kitchen waste), recyclable materials (e.g. metal, glass) and so on, is the foundation for integrated MSWM [4].
The new academic achievements could help to improve the overall efficiency of MSWM while using less energy and fewer raw materials at reasonable cost, producing less pollutant and causing less pollution to the environment [8].
Similar to industrial symbiosis, urban symbiosis refers to the use of byproducts (waste) from cities (or urban areas) as alternative raw materials or energy sources for industrial operations [24].
Chen, An overview of municipal solid waste management in Inner Mongolia Autonomous Region, China, Journal of Material Cycles and Waste Management, 13 (2011) 283-292
Sarkis, Emergy analysis of an industrial park: The case of Dalian, China, Science of The Total Environment, 48 (2010) 5273-5283

INTRODUCTION Montmorillonite clays have been known as inorganic ion-exchange materials showing high proton conductivity.
Electrical conductivity in these materials was found to be mainly protonic.
MATERIAL PREPARATION Raw materials were obtained from the Šipovo bentonite deposits, Republic of Srpska.
The WPA-PILC composite materials were prepared by using aqueous solutions of WPA and pillared clay [8-10].
Jonscher, Journal of Materials Science, 16, 2037 (1981)

Currently, magnesium and its alloys are finding wider use application in different branches of industry, successfully can compete with much cheaper construction materials.
Acknowledgments This work was carried out with the financial support of the Ministry of Science and Higher Education under grant No.
Campbell, Lightweight Materials, Understanding the Basics, ASM International (2012)
Wen Jiang, Effect of Nd and Y Addition on Microstructure and Mechanical Properties of Extruded Mg-Zn-Zr Alloy, Materials Science Forum, 546-549 (2007) 413-416
Szala, Microstructure and fluidity of sand cast ZRE1 alloy, Journal of Achievements in Materials and Manufacturing Engineering, 26 (2008) 2

Study on Green Supply Chain of Chinese TV Industry Under Circular Economy Jiliang Zheng1, a, Fei Zhou1, b, Zhenjiang Qi1, c 1Faculty of Management and Economics, Kunming University of Science and Technology, Kunming, P.R.
It should mainly concern the advancement of material itself, the safety of production process, the rationality of material use and so on.
And the selected material includes recyclable and reusable material, renewable material, degradable material, tractable material and molecular design material, etc.
TV manufactures should take comprehensive conversation with suppliers about green material, and put forward some green requirements for the supply of material.
In the selecting of packing material, TV manufacturers should not select the packing material which contain lead, mercury, tin and other toxic ingredients, but select the recyclable and degradable packing material.

Due to the adsorption effect of clay soil, the concentration of contaminants will continually accumulated in the barrier materials.
Acknowledgements This work was financially supported by the National Natural Science Foundation of China (40802065), Ph.D.
Programs Foundation of Ministry of Education of China (2100092120049) and Key Project of Natural Science Foundation of Jiangsu Province (BK2010060).
Applied Clay Science.
Journal of Guilin Institute of Technology.

Sarma has proposed the limiting equilibrium methods of slices that obliquely slices the sliding mass and taken account of the failure criteria of the material on inter-slice boundaries [2, 3, 4].
The example Slope 2, as shown in Figure 3, has a weak layer underneath, and the material parameters of upper and lower soil layer and the weak layer are presented in Table 4.
Acknowledgements This work was financially supported by the Ningxia Natural Science Foundation (NZ0515) and the National Natural Science Foundation of China (50568003).
(John wiley and Sons, New York 1973),.p.47 [7] M.C.Yang:Chinese Journal of Rock Mechanics and Engineering.
Price: The Computer Journal. (1967), p. 388 [10] E.Spencer: Geotechnique.

Introduction Remanufacturing can strongly be classified as a new era of profitability as it helps in reducing the demands for raw materials and energy to produce units.
In a different work, a comparison of the original manufacture with the remanufacture of components from a typical Caterpillar diesel engine was described by [9] in two measures of environmental performance: energy and material usage.
[13] Chao-Ton Su, Pa-Chun Wang, Yan-Cheng Chen , Li-Fei Chen, Data Mining Techniques for Assisting the Diagnosis of Pressure Ulcer Development in Surgical Patients, Journal of Medical Systems. 36 (2012) 2387-2399
[14] Masayuki Itagaki, Eri Takamiya, Kunihiro Watanabe, Takanori Nukaga, Fumio Umemura, Diagnosis of Quality of Fresh Water for Carbon Steel Corrosion by Mahalanobis Distance, Corrosion Science. 49 (2007) 3408-3420
[15] Yixin Chen, John Phillips, ECU Software Abnormal Behavior Detection Based on Mahalanobis-Taguchi Technique, SAE International Journal Passenger Cars-Electron Electric System. 1 (2008) 474-480.

But the scrap phosphor was only required to make as low value construction material.
[4] Cheng Peng, Zhou Bin, Jiangsu Environmental Science and Technology.
[9] Shimizu, R., et al., Journal of Supercritical Fluids. 33(2005) 235-241
Conf. & Exh. on Analysis & Testing of Metallurgical Process & Materials (Supp.: Chemical analysis part B). 32(2012)795-799
[17] Wu Z H, Cormack A N, Journal of Electro ceramics. 10(2003)179-191

At the same time, it can also delay or prevent the steel tube from the premature occurrence of local buckling because of the existence of the concrete, accordingly, the full play of its material performances can be guaranteed.
However, concrete-filled steel tube arch bridge is different from steel arch bridge，concrete arch bridge and masonry arch bridge in various aspects like materials and composition of the rib, section size and construction methods ect.
Acknowledgments The project is supported by The Director Fund Project of Key Laboratory of Disaster Prevention and Structural Safety of Ministry of Education(2009TMZR004), Guangxi Science Research and Technology Development Project(0992027-9), Graduate Education Innovation Project in Guangxi.
Journal of China Highway, 2000, 13(2): 52-56.
Journal of Fuzhou University(Natural Science Edition): 1999, 27(3): 15-21.