Paper Titles
Formation and Control of Two Side Direction Burr
p.39
White Layer and Surface Roughness in High Speed Milling of P20 Steel
p.45
Research on Technology and Application of Pulse Electrochemical Finishing
p.55
Study on the Ultrasonic Machining of Hydroxyapatite/SiCw Composite Bioceramics Material
p.61
Precision Grinding and Slicing of Glass-Like-Carbon
p.65
Finite Element Modeling of Burr Formation in Metal Cutting with a Backup Material
p.71
Application of Taguchi Method for Optimization of Finishing Conditions in SUS440 Stainless Steel Substrate
p.77
The Standardization for the Edge Quality of the Precise Machining Products
p.83
Surface Quality of Finishing Cut by WEDM in Gas
p.91

Precision Grinding and Slicing of Glass-Like-Carbon

Article Preview

Abstract:

High density and isotropic poreless structure of Glass-like-carbon makes it practically used for fuel cells of space-shuttles and hard disk substrate etc. Glass-like-carbon is one of the new materials which attract attention, but it is so hard and brittle that precise machining of this material is difficult. Surface grinding and slicing were performed to collect the fundamental data of precise machining. The main results obtained in this study are as follows. (1) The transition from brittle mode to ductile mode in surface grinding occurs at a grain mesh size between #5000 and #3000. (2) The maximum grain depth of cut ‘dg’ necessary for ductile mode grinding is 0.021-0.006 mm or less. (3) When it is being sliced, the kerf width of the #1000 grinding wheel becomes wider than that of the #2000 grinding wheel because of the fact that the material removal capability of the #1000 grinding wheel is bigger than that of the #2000 grinding wheel. (4) It is extremely effective to use the fine grinding wheel, since the Young's modulus of glass-like-carbon is considerably low and eventually causes compression transformation,.

You might also be interested in these eBooks
Precision Surface Finishing and Deburring Technology View Preview

Info:

Periodical:

Advanced Materials Research (Volumes 24-25)

Pages:

65-70

DOI:

https://doi.org/10.4028/www.scientific.net/AMR.24-25.65

Citation:

Cite this paper

Online since:

September 2007

Authors:

Y. Hasuda, Y. Suzuki, T. Kato, R. Meguriya, T. Furusawa, T. Ohashi

Keywords:

Brittle Fracture Mode, Diamond Grinding, Ductile, Fracture Mode, Glass-Like Carbon

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

© 2007 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

References

[1] M. Miyasita: Ductile Mode Grinding Technology for Brittle Materials, J. Japan Soc. Prec. Eng., 56, 5(1990)782.

Google Scholar

[2] S. Yoshida and H. Ito: Present and Future of Ductile-regime Grinding of Optical Parts, J. Japan Soc. Prec. Eng., 56, 5(1990)820.

Google Scholar

[3] Yuichi Hasuda & Kozo Kishi: Edge-chipping Generation of Ferrite in Slot Grinding, Int. J. Japan Soc. Prec. Eng., 30, 3 (1996), 223.

Google Scholar

[4] Yuichi Hasuda & Kozo Kishi: The influence of the bond for grinding wheel on the generation of ground groove of ferrite in slot grinding, J. Japan Soc. Prec. Eng., 62, 10 (1996), 1454.

DOI: 10.2493/jjspe.62.1454

Google Scholar