Papers by Author: J. Chen

Abstract: Thermally stimulated current spectroscopy (TSC) has been applied to characterize deep traps in high-purity semi-insulating 6H-SiC substrates. By using above bandgap to sub-bandgap light for illumination at 83 K and different applied biases, at least nine TSC traps in the temperature range of 80 to 400 K can be consistently observed. It is found that TSC peaks for T < 130 K are significantly affected by light and some peaks are strongly enhanced by the applied bias. Measured trap activation energies range from 0.15 eV to 0.76 eV. Theoretical fittings of selected traps give more accurate trap parameters. Based on literature results connected with deep traps in conductive 6H-SiC, the origin of these TSC traps is discussed.

Abstract: Over the past year, II-VI has transitioned from 2” to 3” commercial SiC substrates. Large-diameter semi-insulating 6H-SiC and n-type 4H-SiC single crystals are grown using the Advanced PVT growth process. Expansion of boule diameter from 2 to 3 and up to 4.25 inches has been carried out using a specially designed growth technique. Stable semi-insulating properties in 6H-SiC are achieved by precise vanadium compensation. The technique of compensation is optimized to produce a controlled and spatially uniform distribution of vanadium and high and spatially uniform electrical resistivity reaching 10 10 – 1011
·cm. N-type 3-inch 4H-SiC crystals are grown using doping with nitrogen, and 3-inch 4H-SiC substrates show uniform resistivity of about 0.018
·cm. The best quality semiinsulating (SI) 3” 6H-SiC substrates demonstrate micropipe density of 3 cm-2, and n-type 3” 4H-SiC substrates - about 1 cm-2. X-ray rocking curve topography of the produced 3” SiC substrates is used for evaluation of their crystal quality.

Abstract: II-VI has developed an Advanced PVT (APVT) process for the growth of nominally undoped (vanadium-free) semi-insulating 2” and 3” diameter 6H-SiC crystals with room temperature resistivity up to 1010 W·cm. The process utilizes high-purity SiC source and employs special measures aimed at the reduction of the impurity background. The APVT-grown material demonstrates concentrations of B and N reduced to about 2·1015cm-3. Wafer resistivity has been studied and correlated with Schottky barrier capacitance, yielding the density of deep compensating centers in 6H-SiC in the low 1015 cm-3 range for both ntype and p-type material. The nearly equal density of deep donors and deep acceptors ndicates that the centers responsible for the intrinsic compensation can be amphoteric. TheEPR density of spins from free carbon vacancies is about 1014 cm-3. It is also hypothesized that impurity-vacancy complexes can be present in the undoped material and participate in compensation.

Abstract: Semi-insulating 6H SiC substrates, 2”, 3” and 100mm in diameter, and n+ 4H SiC substrates, 2” and 3” in diameter, are grown at II-VI using the Advanced Physical Vapor Transport (APVT) technique [1]. The process utilizes high-purity SiC source and employs special measures aimed at the reduction of background contamination. Semi-insulating properties are achieved by precise vanadium compensation, which yields substrates with stable and uniform electrical resistivity reaching ~ 1011 Ω-cm and higher. Conductive n+ 4H SiC crystals with the spatially uniform resistivity of 0.02 W-cm are grown using nitrogen doping. Crystal quality of the substrates, their electrical properties and low temperature photoluminescence are discussed.