Papers by Author: M. Italia

Abstract: The fabrication of SiC MEMS-based sensors requires new processes able to realize microstructures on either bulk material or on the SiC surface. The hetero-epitaxial growth of 3C-SiC on silicon substrates allows one to overcome the traditional limitations of SiC micro-fabrication. In this work a comparison between single crystal and poly crystal 3C-SiC micro-machined structures will be presented. The free-standing structures realized (cantilevers and membrane) are also a suitable method for residual field stress investigation in 3C-SiC films. Measurement of the Raman shift indicates that the mono and poly-crystal 3C-SiC structures release the stress in different ways. Finite element analysis was performed to determine the stress field inside the films and provided a good fit to the experimental data. A comprehensive experimental and theoretical study of 3C-SiC MEMS structures has been performed and is presented.

Abstract: Growth of 3C-SiC films on an off-axis (111) Si substrate, with a miscut of 4° towards the <110> direction, is here reported. An extensive material characterization has been conducted by means of Scanning Electron Microscopy (SEM), Transmission Electron Microscopy (TEM), X-Ray Diffraction (XRD) and Raman spectroscopy, indicating a very promising film quality with extremely flat surface and interface. Notwithstanding the excellent film quality, the wafer bow is still limiting its full employment in device realization.

Abstract: The choice of off-axis (111) Si substrates is poorly reported in literature despite of the ability of such an oriented Si substrate in the reduction of stacking faults generation and propagation. The introduction of off-axis surface would be relevant for the suppression of incoherent boundaries. We grew 3C-SiC films on (111) Si substrates with a miscut angle from 3° to 6° along <110> and <11 >. The film quality was proved to be high by X-Ray diffraction (XRD) characterization. Transmission electron microscopy was performed to give an evaluation of the stacking fault density while pole figures were conducted to detect microtwins. Good quality single crystal 3C-SiC films were finally grown on 6 inch off-axis (111)Si substrate. The generated stress on both 2 and 6 inch 3C-SiC wafers has been analyzed and discussed.