Comparative Analysis for the Anti-Vibration Isolation of a Foundation in the Case of an Elevating Mechanism

Abstract:

To study the vibrations of a Multiparker lift lift model, use various models for the lifting mechanism. In order to increase the number of parking spaces in the center of the Romanian capital, it is intended to design a parking lot on several levels above the Dâmbovița river, which would include two elevators for lifting and lowering cars. One of the elevators works as a system of translating cam and roller translating follower and thus, due to transmitting the torque from the electric drive motor to the cam, respectively changing the travel direction at the end of the route, upon starting and stopping, vibrations may occur within the elevator. This system must be supported on a foundation in order to achieve anti-vibration isolation. There are several possibilities to achieve this anti-vibration isolation, among which one can mention the elastic suspensions mounted on springs, rubber mats or standardized elastic rubber elements

• Periodical: Advanced Engineering Forum (Volume 42)
• Pages: 91-98
• DOI: https://doi.org/10.4028/www.scientific.net/AEF.42.91
• Online since: September 2021
• Authors: Carmen Elisabeta Radu*, Edward Rășchitor, Iosif Tempea
• Keywords: Anti-Vibration Isolation, Foundation on Coil Springs, On a Rubber Mat, On Standardized Elastic Rubber Elements

References

[1] C.E, Radu, E.Rășchitor, I.Tempea, Evaluation of Own Pulses in the Event of Free Vibrations of a Multiparker Type Parking Machine Lifting Machine, Advances Engineering Forum , ISSN:2234-991X, Vol.34, pp.137-142, https://www.scientific.net.

DOI: 10.4028/www.scientific.net/aef.34.137

[2] Ghe, Ene, C, Pavel, Introduction to the technique of vibration and noise isolation - MATRIX ROM – Bucharest (2012).

[3] Ghe., Buzdugan, Car anti-vibration isolation) – Academy Publishing House – Bucharest (1980).

[4] K. Sándor, Programarea interfețelor cu VISUAL BASIC 6.0 (Programming interfaces with VISUAL BASIC 6.0) – The Blue Publishing House, Cluj- Napoca (2002).

[5] I.,Sebeșan, D., Hanganu, Design of suspensions for vehicles on rails – Technical Publishing House, Bucharest 1993 – Chapter 3 Elastic rubber elements.

[6] P.; Bratu, Elastic supporting systems for cars and equipment – Technical Publishing House, Bucharest (1990).

[7] C.E, Radu, E.Rășchitor, V.E, Ștefănescu, I.Tempea, Anti-Vibration Isolation Of A Foundation For An Elevating Mechanism By Means Of Rubber, Fiability & Durability No 2/ 2020, Editura Academica Brâncuşi,, Târgu Jiu, pp.122-127, ISSN 1844 – 640X.

DOI: 10.4028/www.scientific.net/aef.42.91