Optimization of the Raw Part Shape for the “Fork” Production by Computer Simulation

Abstract:

The article showed procedure of forging technological flow design modification of real component “fork”, with using of computer simulation. By using of the primary technological process at production was produced failure forgings, checking simulation showed incorrect material flow in filling of die cavity, and therefore it was needed to raw part design modifications. These modifications were suggested on base results obtained from simulation, the results were abolition of defects, resolution of problem and correctness verification of final forging technological flow.

• Periodical: Applied Mechanics and Materials (Volumes 152-154)
• Pages: 1675-1678
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.152-154.1675
• Online since: January 2012
• Authors: Miroslava Kostalova, Maria Kapustova
• Keywords: Die Forging, Forged Part, Optimization, Raw Part, Simulation

References

[1] Bača, J., Bílik, J. Technology of forming. Printing Publishing STU in Bratislava, 2000. p.233.

[2] Bílik, Jozef - Kapustová, Mária: The analysis of closed-die forging process with the help of computer simulation. Analiza procesu kucia matrycowego za pomoca symulacji komputerowej. In: Hutnik- Wiadomości Hutnicze. - ISSN 1230-3534. - Nr 8 (2008).

DOI: 10.15199/24.2017.5.3

[3] Kapustová, Mária - Košťálová, Miroslava: Consequence of computer simulation for verification of closed die cavity shape. In: Scientific Bulletin. - ISSN 1224-3264. - Vol. XXI International Multidisciplinary Conference. 7th. Baia Mare, Romania, May 17-18, 2007 (2007).

[4] Kapustová, Mária - Košťálová, Miroslava: Blocking die impression shape design using computer simulation. In: Machine Design: On the Occasion of the 47th Anniversary of the Faculty of Technical Sciences. 1960-2007. - Novi Sad : Faculty of Technical Sciences, 2007. - ISBN 978-86-7892-038-7. - S. 33-36.

DOI: 10.24867/grid-2020-p68