Research on Contour Interpolation in Reverse Engineering

Abstract:

In reverse engineering and rapid prototyping, several intermediate contours interpolated between adjacent two-layer ICT slice are needed to meet the requirement of rapid prototyping. A method of linear interpolation based on minimum distance is adopted in this paper. On the basis of the research on interpolation problem between single contours, some researches on the interpolation problem of multiply contours was done in this paper. Satisfactory results are attained by the experiments of a vehicle engine.

• Periodical: Applied Mechanics and Materials (Volumes 170-173)
• Pages: 3304-3307
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.170-173.3304
• Online since: May 2012
• Authors: Hong Liang Wang, Hai Fei Ding, Jin Qi Wang
• Keywords: Contour Interpolation, Industrial CT, Rapid Prototyping (RP)

References

[1] Weiguo Zhen, Yongnian Yan, Qingping Lu, and Hehe Zhou: China Mechanical Engineering.Vol.13 (2002), p.1734, in Chinese.

[2] Gaofei Wang, Tao Ning, Ping Xi, and Rongxi Tang: Manufacturing Automation.Vol.25 (2003), p.8, in Chinese.

[3] Ye Yuan, Zongying Ou, and Jianhua Hou: Mechanical Science and Technology. Vol.20 (2001), p.962, in Chinese.

[4] Shuangteng Zhang, and Taiyi Zhang: Journal of Chongqing University. Vol.17 (1994), p.1, in Chinese.

[5] Jian Wu, Zhiming Cui, Feng Ye, and Qun Wang: Computer Applications and Software. Vol.25 (2008), p.63, in Chinese.

[6] Chao Jia, Zhigang Han, and Sujun Chen: Computer Engineering and Applications. Vol.43 (2007), p.78, in Chinese.