Study on Design the Stop Pipe Diameter of Packaging Power-Law Fluid

Abstract:

The distribution of the speed and shear stress in power-law fluid with the laminar flow in the pipe were analyzed in this paper, then, the flow rate was calculated. Moreover, the stop pipe diameter was designed by calculating the balance of shear stress of power-law fluid in the pipe and the gravity of filling fluid. The conclusion: Ideal stop pipe diameter of power-law fluid is related to fluid properties, pressure and the acceleration of gravity.

• Periodical: Applied Mechanics and Materials (Volumes 198-199)
• Pages: 128-132
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.198-199.128
• Online since: September 2012
• Authors: Yong Ding, Fu Xin Yang, Jian Qiang Bao
• Keywords: Diameter, Flow Rate, Power-Law Fluid, Speed, Stress

References

[1] L.Q. Wu and L.D. Kong: Journal of Agricultural Machinery vol. 37( 2006), p.211.

[2] L.Q. Wu and F.X. yang: Packaging Engineering vol. 19(1998), p.20.

[3] Y. Ding, X.L. Jia and G.Z. Li: Packaging Engineering vol. 28(2007), p.78.

[4] F.X. Yang: Journal of Agricultural Machinery vol. 37(2006), p.56.

[5] F.X. Yang and Z. Wang: Packaging Engineering vol. 30(2009), p.76.

[6] Y.N. Chen: Applied fluid mechanics (Aviation Industry Publishers, Beijing 2000).

[7] C. Yan, Y.J. Qian and Q.X. Lian: Power-law fluid Mechanics (Beijing University of Aeronautics and Astronautics Publishers, Beijing 2008).

[8] C.R. Smith and J.D. walker: Fluid vortices (kluwer Academic Publishers, Bosten 1995).