Design and Realization of SDRAM Controller Based on FPGA

Article Preview

Abstract:

This article introduces a SDRAM controller based on FPGA. It describes the architecture of controller and takes explain for each module .There is also a timing analysis about data communication between FPGA and SDRAM before post-simulation. Through board verification , a burst mode with auto precharge and full-page mode without auto precharge are achieved and the highest bandwidth in each mode are listed.

You might also be interested in these eBooks

Info:

Periodical:

Pages:

2233-2237

Citation:

Online since:

December 2012

Authors:

Export:

Price:

Permissions CCC:

Permissions PLS:

Сopyright:

© 2013 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

[1] Yunqing Liu, Tong Shoufeng. The design of SDRAM controller utilizing FPGA, Sci. Tech. Vol. 7 (2005) , 50, In Chinese.

Google Scholar

[2] YangHaitao, SuTao, The design and implementation of the SDRAM controller based on FPGA, Electroni Sci. &Tech Vol. 1(2007), 8, In Chinese.

Google Scholar

[3] SDR SDRAM controller white paper on http: /www. altera. com.

Google Scholar

[4] LuJun, GaoLe, Design and realization of the SDRAM controller in an embedded panoramic image processing system based on FPGA , applied Sci. &Tech. Vol. 39(2012), 55-60, In Chinese.

Google Scholar

[5] TianYun, XuWenbo, Guide of Xilinx FPGA development, TsinghuaUniversity Press, BeiJing, 2008, In Chinese.

Google Scholar

[6] Hynix Corporation HY57V641620FTP Datasheet on http: /www. hynix. com.

Google Scholar