Simulation on the Wear of Micro Mill Cutter in Micro Milling

Abstract:

Article Preview

In this paper, the prediction model of micro-milling cutters in milling process is established to simulate the wear depth in the software DEFORM-3D, the chips growing up an forming process. The paper studies the wear level during the cutting process of micro milling amount of feed per tooth and spindle speed. In this paper the cutting force, cutting heat flow and the contact situation between cutting tool and workpiece are considered in the simulation model. The paper uses abrasion mathematical model related to contact stress and temperature, etc. and studies the influence of the wear depth of milling cutter through the analysis of milling temperature and metal sliding characteristics. Finally, the FEA micro –soft ware is used to verify the change of amount of feed per tooth and the spindle speed with wear depth. The paper provides reasonable parameters for using the micro milling cutter better.

Info:

Periodical:

Edited by:

Bo Zhao, Yidu Zhang, Guanglin Wang, Hai Zhang, Jianbin Zhang and Feng Jiao

Pages:

476-479

DOI:

10.4028/www.scientific.net/AMM.42.476

Citation:

H. J. Hu et al., "Simulation on the Wear of Micro Mill Cutter in Micro Milling", Applied Mechanics and Materials, Vol. 42, pp. 476-479, 2011

Online since:

November 2010

Export:

Price:

$35.00

In order to see related information, you need to Login.

In order to see related information, you need to Login.