Design of High-Speed Communication on the Detection Equipment

Abstract:

After the equipment of a new equipment, the cambat effectiveness has been greatly improved. The lack of a intelligent fault diagnosis system delayed the generation of equipment support ability, so a kind of detection equipment which can intelligently and quickly diagnose the fault was urgently needed .Based on the field programmable gate array (FPGA) and ARM platform, this paper gives a design of a high-speed digital processing detector. Using the serial communication, it can not only transmit a variety of common signal at a high speed, but also eliminate the interference between the transmission lines. As serial communication has no synchronous problem, there's more room to improve the transmission speed.

• Periodical: Applied Mechanics and Materials (Volumes 496-500)
• Pages: 1390-1393
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.496-500.1390
• Online since: January 2014
• Authors: Wei Xin Zhang*, Wei Bing Bai, Lin Tao Li, Ji Wen Hu, Chao Feng
• Keywords: ARM, Communication, FPGA, SPI

References

[1] EDA Pioneer Studio: Altera FPGA/CPLD Design (fundamental). The people's University of Posts and Telecommunications(2010).

[2] Cui Jian: The design of high-speed data acquisition card based on the FPGA and ARM(2006), p.4-p.10.

[3] Liang Dongying: Based on wavelet transform signal power filter adjustment and analysis. Journal of Shenzhen Institute of Information Technology. Forum Vol. 6(2008), p.38-p.40.

[4] Xilinx: Spartan-3A/3AN Starter Kit Board User Guide UG334(v1. 0), (May 28, 2007), p.122-p.135.

[5] S5PV210 RISC Microprocessor Revision 1. 00, (February 2010), p.220-p.250.