Conception of Virtual Machine Model Based on MCM

Abstract:

It is therefore important to implement into practice of uncertainty estimation of coordinate measurement new, correct and metrologically validated methods.because according to technological requirements, results of measurements are useful only when they are given with their accuracy. Currently used methods for uncertainty assessment are difficult and require knowledge and measuring experience. It is therefore important to implement correct and validated methods that will also be easy to implement and will not require broad metrological knowledge from the personnel. Presented here simulation method, based on Monte Carlo method is one of them. The article presents the conception, implementation and validation of this method.

• Periodical: Applied Mechanics and Materials (Volumes 556-562)
• Pages: 5564-5567
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.556-562.5564
• Online since: May 2014
• Authors: Yong Jun Jiang*
• Keywords: Conception, Error, Measuring, Spheres

References

[1] E.M. Barini, G. Tosello, L. De ChiffreUncertainty analysis of point-by-point sampling complex surfaces using touch probe CMMs: DOE for complex surfaces verification with CMM Precis. Eng., 34 (1) (2010), p.16–21.

DOI: 10.1016/j.precisioneng.2009.06.009

[2] M.A. Green: High Efficiency Silicon Solar Cells (Trans Tech Publications, Switzerland 1987). Beaman, E. Morse Experimental evaluation of software estimates of task specific measurement uncertainty for CMMs Precis. Eng., 34 (1) (2010), p.28–33.

DOI: 10.1016/j.precisioneng.2009.08.006

[3] P. Bleys, N. Van Gestel, S. Cuypers, J. -P. Kruth, Uncertainty due to limited sampling of circular features on coordinate measuring machine, in: Proc. of the 10th CIRP Conference on Computer Aided Tolerancing, Erlangen, Germany, March (2007).

[4] H. Schwenke, W. Knapp, H. Haitjema, A. Weckenmann, R. Schmitt, F. Delbressine Geometric error measurement and compensation of machines—An update CIRP Ann., 57 (2) (2008), p.660–675.

DOI: 10.1016/j.cirp.2008.09.008

[5] W. Lotze, U. Teichmann Einfluss von Gestalt- und Lageabweichungen auf die Unsicherheit der Rechnergestützehn Koordinatenmessung Feingerätetechnik, 8 (1976), p.139–343.

[6] W. Lotze Rechnergestützte Koordinatenmesstechnik Werkstatt und Betrieb, 113 (6) (1980), p.391–395.

[7] W. Lotze Prfkrper fr Koordinatenmegerten Feingertetechnik, 30 (1981), p.154–155.

[8] J. S adek Modeling and evaluation of coordinate measuring machines accuracy Cracow University of Technology, Cracow (2001).

[9] VDI/VDE 2617 Accuracy of coordinate measuring machines. Parameters and their reverification.

[10] A. Gaska, Modeling of accuracy of coordinate measurement with use of Monte Carlo Method. PhD Dissertation, Cracow University of Technology. Cracow, (2011).