Dimensional Characterization of Surface Contours of Cut Surfaces with Plasma Straight Metallic Materials

Abstract:

The purpose of this paper is to analyze the dimensional accuracy of the surfaces straight edges from cutting plasma free atmosphere or water bed. The aim was to identify any defects and if bed piss water cut in some way influence the surface quality and dimensional contours right. Mechanical thermal plasma cutting bed prevents overheating of the water has the advantage that the base material and thus the parameters related to compliance with the slag assures cut pieces at the bottom, this saves the cost of production. Mechanized plasma cutting bed heat the water does not affect the value of angle tolerance compared to cutting outdoor (angular deviation determined either for parts or cut outdoor water bed ranged between 7-9 degrees / side). The causes of and ways to reduce the deviation angle cut edge is determined by other factors such as cutting speed, distance torch-material, cutting nozzle erosion.

• Periodical: Applied Mechanics and Materials (Volumes 754-755)
• Pages: 724-727
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.754-755.724
• Online since: April 2015
• Authors: Teodor Machedon-Pisu, Hussin Kamarudin, Elena Machedon Pisu*
• Keywords: Cut Surface, Dimensional Accuracy, Plasma Thermal Cutting, Water Bed

References

[1] S.M., Ilii, M., Coteata, A., Munteanu, Experimental results concerning the variation of surface roughness parameter (Ra) at plasma arc cutting of a stainless steel workpiece, 2010, International Journal of Modern Manufacturing Technologies, II/1: 31-36.

[2] S.M., Phadke, Quality Engineering Using Robust Design, 1989, Prentice Hall.

[3] K. V. Vasil'ev Plasma-arc cutting – a promising method of thermal cutting, 2003 în WELDING INTERNATIONAL Volume 17, Number 2, 147 151, DOI: 10. 1533/wint 3096.

DOI: 10.1533/wint.2003.3096

[4] R., Bini, B.M., Colosimo A.E., Kutlu, M. Monno, Experimental study of the features of the kerf generated by a 200 A high tolerance plasma arc cutting system, 2008 in Journal of Materials Processing Technology Volume 196, Issues 1-3, 21 January 2008, Pages 345-355.

DOI: 10.1016/j.jmatprotec.2007.05.061

[5] SR EN ISO 9013: 2003 Thermal cutting. Classification of thermal cuts. Geometrical product specification and quality tolerances.

DOI: 10.3403/02688983

[6] M.C. Perju, P. Vizureanu, Chemical Compounds Analysis Developed on the Micro Alloying Area of Coating Layers Obtained by Impulse Discharge Method, Revista de Chimie (Bucharest) 65, 6, (2014) 694-696.

[7] C.M. Bortun, B. Ghiban, N. Ghiban, L. Ardelean, Rusu, L.C., Surface Characterization of Some CoCrMo Alloys Used in RPD Technology, Revista de Chimie (Bucharest) 63, 9, (2012) 906-910.

DOI: 10.4028/www.scientific.net/kem.583.36