Stratified Flow Condensation of CO₂ in a Tube at Low Temperatures

Abstract:

This study presents an experimental investigation of CO₂ flowing condensation at the saturation temperature of-10°C, mass flux in the range from 40 to 60kgm^-2s^-1 and vapour quality ranging from 0.2 to 0.8, in a 6.52mm inside diameter horizontal tube. Previous research on refrigerant condensation has shown that under these conditions, CO₂ two phases are expected to develop as a stratified flow. The significant feature of the stratified flow heat transfer is vapour film condensation in the upper region which dominates the overall heat transfer process. Test series in this study confirm that the saturation-to-tube wall temperature difference has a significant influence on the condensing heat transfer coefficient when the temperature difference is within 3K. Comparisons between the experimental results and the predictions by the Dobson, Cavallini and Thome models show that CO₂ stratified flow condensation heat transfer coefficients are over-predicted by these models with mean deviations of 104%, 81% and 127%, respectively.

• Periodical: Applied Mechanics and Materials (Volumes 789-790)
• Pages: 184-192
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.789-790.184
• Online since: September 2015
• Authors: Pei Hua Li, Joe Deans, Stuart Norris*
• Keywords: Carbon Dioxide, Condensation, Stratified Flow

References

[1] Nusselt, W., Die Oberflachencondensation des Wasserdampfes. Z. Vereins desutscher Ininuere, 1916. 60: pp.541-569.

[2] Dobson, M.K. and J.C. Chato, Condensation in smooth horizontal tubes. Journal of Heat Transfer-Transactions of the Asme, 1998. 120(1): pp.193-213.

DOI: 10.1115/1.2830043

[3] Cavallini, A., et al., In-tube Condensation of Halogenated Refrigerants. ASHRAE Transactions, 2002. 108: p.146.

[4] Thome, J.R., J. El Hajal, and A. Cavallini, Condensation in horizontal tubes, part 2: New heat transfer model based on flow regimes. International Journal of Heat and Mass Transfer, 2003. 46(18): pp.3365-3387.

DOI: 10.1016/s0017-9310(03)00140-6

[5] Chato, J.C., Laminar Condensation Inside Horizontal and Inclined Tubes. ASHRAE Journal, 1962. 4: pp.52-60.

[6] Sparrow, W.M.G., J.L., A boundary-layer treatment of laminar film condensation. Journal of Heat Transfer, 1959. 81: pp.13-23.

DOI: 10.1115/1.4008118

[7] Koh, J.C.Y., Sparrow, E.M., Hartnett, J.P., The two-phase boundary layer in laminar film condensation. International Journal of Heat and Mass Transfer, 1961. 2: pp.69-82.

DOI: 10.1016/0017-9310(61)90015-1

[8] El Hajal, J., J.R. Thome, and A. Cavallini, Condensation in horizontal tubes, part 1: Two-phase flow pattern map. International Journal of Heat and Mass Transfer, 2003. 46(18): pp.3349-3363.

DOI: 10.1016/s0017-9310(03)00139-x

[9] Kattan, N., J.R. Thome, and D. Favrat, Flow boiling in horizontal tubes: Part 1 - Development of a diabatic two-phase flow pattern map. Journal of Heat Transfer, 1998. 120(1): pp.140-146.

DOI: 10.1115/1.2830037

[10] Zivi, S.M., Estimation of Steady-State Steam Void-Fraction by Means of the Principle of Minimum Entropy Production. Journal of Heat Transfer, 1964. 86(2): pp.247-251.

DOI: 10.1115/1.3687113

[11] Steiner, D., Heat transfer to boiling saturated liquids. VDI-Wär Meatlas (VDI Heat Atlas), (1993).

[12] Iqbal, O. and P. Bansal, In-tube condensation heat transfer of CO2 at low temperatures in a horizontal smooth tube. International Journal of Refrigeration, 2012. 35(2): pp.270-277.

DOI: 10.1016/j.ijrefrig.2011.10.015

[13] Shah, R.K. and A.L. London, Laminar flow forced convection in ducts : a source book for compact heat exchanger analytical data. 1978, New York: Academic Press.

[14] Nellis, G. and S. Klein, Heat Transfer. 2012: Cambridge University Press.