Study on Technology of Filter Made by Engineering Grade Thermoplastic Polyurethane

Abstract:

This paper introduced the different classifications and advantages of the project level thermoplastic polyurethane elastomer ,and according to the injection molding process of raw materials Isoplast 302EZ and thermoplastic polyurethane elastomer, from raw material preparation, injection machine selection, tooling selection, molding conditions, and introduced TPU injection molding process .The filter housing of TPU were briefly discussed from the design goals, technical characteristics, performance analysis. Combination of typical products, we studied the technology of the production of the thermoplastic polyurethane flexible filter housing. The results showed that the material should be pre-dried in a vacuum, and the time, temperature and pressure should be controlled properly. It should be pay attention that the specification of the waste and the raw materials should be the same, when recycling and on the other hand, the quality of the productions should be improved and no pollution should be ensure during the process; to avoid the decomposition temperature and the products aging, we should empty the material or stop the machine during it doesn’t work.

• Periodical: Advanced Materials Research (Volumes 217-218)
• Pages: 746-751
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.217-218.746
• Online since: March 2011
• Authors: Jia Min Zhang
• Keywords: Filter, Injection Molding Technology, Thermoplastic Polyurethane (TPU)

References

[1] Hua BAO, Zhiping ZHANG, Shengkang YING. MICROPHASE SEPARATION OF CARBOXYLIC POLYURETHANEUREA EMULSIONS[J]. Synthesize Rubber industry, In Chinese. 1996, 19(5): 281-283.

[2] Limin LI, Wengang LI, Xiangan HUANG. The Studies of the Effect of Heat History on the Propertiesand Micro-phase Separation of the Thermoplastic Polyurethane. Polyurethane Industry, In Chinese. 2004, l9(1): 9-11.

[3] Changchun ZHU, Jinhe GU. Production, Processing and Application of Thermoplastic Polyurethane. Chemical Propellants & Polymeric Materials, In Chinese. 2005, 3(2): 40-45.

[4] Shuling REN. The Cause and Treating Measures of Thermoplastic Polyurethane Injection. Polyurethane Industry, In Chinese. 2005, 20(2): 34-37.

[5] Xiaoping Chen, Yun Wang, Shugen Hu, Xiaowen Song. Optimization of injection molding process based on flow simulation technology . Mechanical Design and Manufacturing, In Chinese. 2005, 2: 68-69.