Study on the Brazing Technology and Mechanical Properties Using bmp7 Filler Metal

Abstract:

The 1Cr18Ni9Ti stainless steel was brazed in the argon shield and впр7 as the filler metal. The spreadability and clearance fillability of впр7 on 1Cr18Ni9Ti stainless steel was evaluated at different temperatures and the optimum brazing temperature was clearly demonstrated as 1170~1190°C. Scanning electron microscope (SEM) study combined with energy dispersive spectrometer (EDS) showed the presence of many undissolved elements and voids in the joints while the brazing clearance is 0.15mm, which directly caused a low joint shearing strength. Almost no undissolved brittle compounds were observed while the brazing clearance stands in a range of 0.01mm~0.10mm. Therefore, a Ni-based solid solution with good performance was obtained in the joint. Those brazing parameters matching with the holding time 8~10min could bring the joint a typical performance which fully satisfies Russian standard. These conclusions had been proved by joint stress-rupture and low cycle fatigue tests.

• Periodical: Advanced Materials Research (Volumes 295-297)
• Pages: 1879-1884
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.295-297.1879
• Online since: July 2011
• Authors: Xiao Zhen Hua, Wen Ting Guo, Yong Tao Xu, Zhi Guo Ye, Ai Hua Zou, Xian Liang Zhou
• Keywords: Brazing Clearance, Brazing Temperature, Mechanical Property, ВNP7

References

[1] Liu Enze, Sun Shuchen, Tu Ganfeng. Transactions of the China welding institution 2007, 28, 10:77-80

[2] Xia Yunling, Li Shujie. etc. Powder Metallurgy Technology 2005(12). 23. 6: 414-417

[3] Yu Zhir shui.. Transactions of the China welding institution2001(12).22.6:29-32

[4] Tang Zhengzhu, Chen Peiyin, WU Wei. Transactions of the China welding institution 2008.1.29(1):109-112

[5] Ren Yaowen. Technology of vacuum brazing[M].1993:17-18(in Chinese)

[6] C. H. Cadden. Brazing. Encyclopedia of Materials: Science and Technology[M] 2008:1-7