Research on Three Dimensional Design of Cavity of Injection Molds of Involute Plastic Gears

Abstract:

The crux to the 3D design of cavity of injection molds for involute plastic gears is to solve the difficulty in zooming the cavity of molds and the accurate molding of the involute tooth profile. Researches have shown that the shrinkage of involute tooth profile is non-linear during the injection molding process of plastic gears. This paper presents the 3D design of cavity of injection molds for involute gears based on SolidWorks after offering an introduction to the relationship between the cavity tooth profile of injection molds for small-modulus plastic gears and the tooth profile of injection molding part.

• Periodical: Advanced Materials Research (Volumes 472-475)
• Pages: 2859-2863
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.472-475.2859
• Online since: February 2012
• Authors: Guang Si Luo
• Keywords: 3-D Design, Cavity of Injection Molds, Involute Gears

References

[1] L.G. Pu:Design of Machinery(Higher Education Press,China 1994).

[2] J.Z.Wu and T.Wang:Dedendum Transition Curve and Dedendum Stress(National Defense Industry Press,China 1989).

[3] Z.G. Sun and X. X.Sun: Mould and Mold Manufacture,2002No.10,pp.33-35(In Chinese).

[4] S.G. Tian: Mould and Mold Industry, 1993No.8,pp.36-38(In Chinese).

[5] R.L. Huang: Mould and Mold Technology, 2009No.4,pp.125-127(In Chinese).

[6] R.W.Ma:Automotive Digest, 2007No, (4-8).