Optimal Design of Rotation Shaft Torque Testing System

Yuan Qiang Jin; Yu Li Zang

doi:10.4028/www.scientific.net/AMR.476-478.1987

Paper Titles

Adsorption of As (v) from Water by Activated Aluminum Oxide
p.1965

One-Pot Synthesis of Mesoporous MCM-41 with Different Functionalization Levels and their Adsorption Abilities to Phosphate
p.1969

Research on Special Cement for the Concrete with Ultra-Fine Iron Tailings
p.1974

Synthesis and Performance of NaA/MCM-48 Micro-Mesoporous Composite Molecular Sieve
p.1979

Optimal Design of Rotation Shaft Torque Testing System
p.1987

The Wear Mechanism Comparison between MgO-Based Chrome-Free Brick and MgO-Cr₂O₃ Brick in the Lower Part of RH Vacuum Degasser
p.1991

Synthesis and Application of Water-Borne Nontoxic Emulsion from Wasted Polystyrene Foam
p.1997

Study on the Photocatalytic Degradation of Ammonia Nitrogen in Aquaculture Wastewater by Fe³⁺-Doped Nano-TiO₂ under UV Irradiation
p.2001

Preparation of Visible Light Response K₆SiW₁₁O₃₉Sn^II for Photocatalytic Degradation of Acid Brilliant Scarlet
p.2005

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 476-478Optimal Design of Rotation Shaft Torque Testing...

Optimal Design of Rotation Shaft Torque Testing System

Abstract:

Torque measuring in the extra-high rotation speed has not been resolved ideally yet, due to the restriction of the rough conditions. The dynamic characteristics of the developed digital plane grating angular-torquer measuring system are analyzed in this paper. The paper mainly calculates and designs the parameters of elastic shafts with different cross-section. Via the compare of dynamic characteristics and compactness of the elastic shafts with different cross-section, the optimized design is proposed at the end of the paper. The achievements of this paper can supply references to the study and design, maintaining and improvement of relative instruments.