Precision Analysis of Reconstructed Aluminum Alloy Handle

Hai Lin Jiang

doi:10.4028/www.scientific.net/AMR.479-481.2226

Paper Titles

Practice on No Pillar Simultaneous Extraction of Coal and Gas in Deep Mine
p.2206

Research on Electronic Ballast Start-Up Mode of High Pressure Sodium Lamp
p.2211

Simulation Design of Bionic Blade on Wind Turbine
p.2215

The Design of the Connecting Rod Rapid Prototyping Based on Reverse Engineering
p.2222

Precision Analysis of Reconstructed Aluminum Alloy Handle
p.2226

Analysis and Reconstruct of Complex Data Based on 3D Laser Scanner
p.2231

Hierarchical Correspondence of 3D Faces Based on Thin Plate Spline Deformation (HCTD)
p.2235

Intelligent Vision Inspection System for IC Engine Head: An ANN Approach
p.2242

Design of Flammable Gas Monitoring Circuit Based on TGS813
p.2246

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 479-481Precision Analysis of Reconstructed Aluminum Alloy...

Precision Analysis of Reconstructed Aluminum Alloy Handle

Abstract:

In order to carry out the error analyses of the aluminum alloy in reverse engineering, Mastercam was used to create three-dimensional (3D) parametric solid models and automatically generate NC program files. By using the generated NC program, a simulating is processed on a milling machine. The surface of the obtained product 1 was immediately scanned by a laser scanner. Using the obtained results from the laser scanner, the three-dimensional models were created in Geomagic Studio. Reanalysis of the three dimensional models, product 2 can be obtained. Finally, Error analysis was carried out by comparing the 3D scan data with the original design models. The current research demonstrates that error analysis by the present method is feasible. However, since aluminum was selected as the processing material, the scanned data is not satisfactory; contrast error is greater after reverse engineering.