Research on the Forming Process of the Y-Shaped Tube Based on ABAQUS

Ling Yun Zhang; Ya Lin Pan; Zhen Jun Li

doi:10.4028/www.scientific.net/AMR.602-604.1942

Paper Titles

The Process Analysis of Commonly Used T-Shaped Tube Compound Bulging Media
p.1926

Modeling and Analysis of Process Parameters for Plastic Injection Molding of Base-Cover
p.1930

Methods of Establishing Forming Limit Diagram of Tube Hydroforming
p.1934

Research on Intelligent Precise Pass Design Algorithms
p.1938

Research on the Forming Process of the Y-Shaped Tube Based on ABAQUS
p.1942

The Effect of Drawing Process on the Properties of Split-Film PTFE Fiber
p.1946

Numerical Simulation of Discrete Die Bending of Rectangular Tube
p.1951

Finite Element Analysis on Flanging Forming of Car Spoke Parts
p.1955

Numerical Simulation on the Microstructure during Extrusion Process of P91 Large Diameter Thick-Walled Tube
p.1959

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 602-604Research on the Forming Process of the Y-Shaped...

Research on the Forming Process of the Y-Shaped Tube Based on ABAQUS

Abstract:

ABAQUS software is used to simulate the stamping process of the Y-shaped tube to study the feasibility of stamping forming. The simulation results are analyzed to study how fabrication holes affect the ability of sheet metal forming. The results show that it is possible to form the Y-shaped tube by stamping; fabrication holes with reasonable size and location can improve the distribution of stress and strain, and enhance the limit deformation ability of the sheet.