Turn-Milling Parameters Optimization Based on Cutter Wear

Chao Huang; Yong Lin Cai

doi:10.4028/www.scientific.net/AMR.602-604.1998

Paper Titles

ANSYS Application in Cutting Stiffness Analysis of a Gearbox’s Back Case
p.1980

Study on the Mechanism and Tool of the Uniform ER Finishing with Changeable Removal Rate Model of Free-Form Surface
p.1984

Optimal Selection of Machining Parameters by Genetic Algorithms for Face-Milling Operations Based on Minimum Unit Machining Time
p.1989

Study on Drill-Through Determination in Vibration Drilling Based on Axial Force
p.1993

Turn-Milling Parameters Optimization Based on Cutter Wear
p.1998

Quality Research on Electric Discharge Machining with Rotary Surface of Engineering Ceramic
p.2002

The Hot Deformation Behavior and Hot Processing Map of CL60 Rail Wheel Steel
p.2006

Experimental Research on the Relation between Processing Parameters and Fractal Dimensions of the Machined Surface
p.2011

Study of the Impact Toughness Experiment of SiCp / Al FGM
p.2017

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 602-604Turn-Milling Parameters Optimization Based on...

Turn-Milling Parameters Optimization Based on Cutter Wear

Abstract:

In this paper, the cutting acreage model of every cutting edge point in turn-milling is established firstly. Then according to the calculation of the above model, the cutter wears with different cutting parameters are analyzed. Aiming at balancing the wears of different areas along the cutting edge, the cutting parameters are changed to optimize the cutter wears. Finally the model and the optimization are proved correct by machining experiments with different cutting parameters.