Design of CTS Measurement & Control System Based on the VXI Bus

Xiao Wei Liu; Yu Ma; Yong Ming Qin

doi:10.4028/www.scientific.net/AMR.622-623.1510

Paper Titles

Fan Speed Control on Heat Detector Technique Using Zigbex Wireless Sensor Network
p.1484

Aeroacoustic Analysis of Automobile Antenna in Various Positions
p.1492

Direct Synthesis Controller Identification
p.1498

A Passivity-Based Power Control Strategy of VSR PWM Rectifier under Unbalance Voltage
p.1503

Design of CTS Measurement & Control System Based on the VXI Bus
p.1510

Optimal Voltage Control for Single-Phase Inverter with Resonant LC Filter via Type-2 ILQ Servo-Control by 2^nd-Order Polynomial
p.1514

Signal Conditioning of Low-Cost Gyroscope Using Kalman Filter and Nonlinear Least Square Method
p.1519

A Novel Testing System of Welds in Tube Nodes Based on Ultrasonic Phased Array Technology
p.1524

Based on Atomic Spectrometry for the Determination of Titanium Element in Molten Steel
p.1528

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 622-623Design of CTS Measurement & Control System Based...

Design of CTS Measurement & Control System Based on the VXI Bus

Abstract:

The Capture Trajectory System (CTS) is an advanced measurement method of the trajectory for store separation in wind tunnel test. According to the characteristics of good real-time, high reliability and a large amount of data processing in the CTS test, an open-architecture measurement & control system based on VXI bus and PMAC2 is proposed in this paper, and its overall scheme design, hardware composition and software structure are described. With IPC, embedded operator and PMAC2 applied, the three level microcomputer structure ensures the system has good real-time and accurate trajectory control. The hierarchical software and the modular design method make sure that the system has good portability, universality and extensibility.