Fault Pattern Recognition for Partial Discharge of Electrical Power Equipment Based on Properties of Electrical Materials

Abstract:

Partial discharge causes mainly the insulation deterioration. It is the significant symptom and manifestation, and is an important factor of the insulation failure for the electrical power equipment. On the basis of analyzing the physical model of partial discharge, this paper used the online monitoring technology of partial discharge that combines the ultra high frequency (UHF) method and the acoustic emission (AE) method, studied the fault pattern recognition method of partial discharge based on the case-based reasoning algorithm, and established the intelligent fault identification system of partial discharge based on the case-based reasoning. The system can accurately and reliably identify the fault mode type, the specific fault location and severity of partial discharge for the electrical power equipment to make the health evaluation and improve the reliability. Through the application of the new materials and new technology, the load loss of the transformer can drop by 15%, the no-load loss can decline by 50% and the fee of electricity loss can down by 32.5%.

• Periodical: Advanced Materials Research (Volume 644)
• Pages: 105-109
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.644.105
• Online since: January 2013
• Authors: Guo Jin Chen, Ming Xu, Ting Ting Liu, Jing Ni, Dong Xie, Yan Ping Zhang
• Keywords: Acoustic Emission (AE), Case-Based Reasoning (CBR), Electrical Power Equipment, Fault Pattern Recognition, Partial Discharge (PD), SF6 Gas Alternative Technology, Ultra-High Frequency (UHF)

References

[1] ZHU Jie, CHEN Guo-jin, WANG Wan-qiang, Applying FPGA on Frequency Convert System of SVPWM, Mechanical & Electrical Engineering Magazine, Vol. 22, No. 4, p.22–25, (2005).

[2] CHEN Guo-jin, YAO Zhai-rong, SUN Hong, Realization of AC Motor Vector Control Based on DSP, Mechanical & Electrical Engineering Magazine, Vol. 21, No. 6, p.27–30, (2004).

[3] WANG Tao, CHEN Guo-jin, NI Jing, Design and application of electric control system on pattern drawing machine, Journal of Mechanical & Electrical Engineering, Vol. 29, No. 4, p.413–416, (2012).

[4] LI Yong-ning, YANG Hua, CHEN Guo-jin, Application of μC/OS-Ⅱ in digital welder control system, Journal of Mechanical & Electrical Engineering, Vol. 28, No. 7, p.827–830, (2011).

[5] CHEN Guo-jin, CHEN Hui-peng, CHEN Li-ping, Research on multidisciplinary modeling and robust control for electric power steering system, Advanced Materials Research, Vol. 179-180, pp.179-185, (2011).

DOI: 10.4028/www.scientific.net/amr.179-180.179