Studies on RC Beams Strength with Steel Wires Using Nolinear Finite Element Method

Abstract:

High strength stainless steel wire mesh-polymer mortar reinforcement method was a kind of advanced reinforcement technique.The present study attempted to do a model analysis on the test of the high strength steel wire mesh-polymer mortar reinforcement of less stress beams by using finite element software ANSYS. The study was conducted through the analysis of the three factors of the tested bending reinforcement beam’s deflection, deformation and stress and comparison of the changes of the beam’s ultimate load and failure mode before and after reinforcement.The results of ANSYS analysis and the test showed that the failure mode shifts from less reinforcement damaged into reinforcement destruction;the crack loading value of the reinforced beams increased indicating that the beam bottom reinforcement layer had a significant effect on the increase of the beam’s crack loading. Increased significantly compared to non-reinforced ultimate bearing capacity of reinforced beams. the ANSYS finite element simulation agrees well with the experimental value.

• Periodical: Advanced Materials Research (Volumes 690-693)
• Pages: 895-899
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.690-693.895
• Online since: May 2013
• Authors: Cao Song, Jing Ya Zhou, Hong Mei Zhang
• Keywords: Concrete Structure, High Strength Steel Wire Mesh, Reinforcement

References

[1] The paper is writing by Jincheng Xun, Jinming Guan. Stainless steel wire mesh - permeability polymer mortar ductility of reinforced concrete slabs assessment [R], Tsinghua University, Department of Civil Engineering, 2000. In Chinese

[2] Write by Neijian Guo,Wanghan Bin.Experimental study of high strength stainless steel wire mesh - permeability polymer mortar flexural strengthening [J].Journal of Building Structures,2005. In Chinese

[3] Write by Liuyan Shun, Liu Tiejiang .Experimental study on flexural cracks of RC beams strengthened with stainless steel wire mesh and permeability polymer mortar[J]. Sichuan Building Science, 2007. In Chinese

[4] Write by Zhu Yanpeng, Liaoyong Shi. Experimental Study on Flexural Behavior of RC Beams Strengthened with Stainless Steel Mesh and Permeability Polymer Mortar [J]. Engineering and Retrofitting .2011. In Chinese

[5] Write by Liu Mingquan. Experiment and Study on Concrete Beam Reinforced by Steel Wires [J]. Construction Technology, 2011. In Chinese

[6] Write by Yaoqiu Lai, Zhang Lifeng, Yaozhi Hua .Studies on RC Beams Strengthened with SMPM Using Finite Element Method [J]. Engineering and Retrofitting, 2009. In Chinese

[7] Write by Li Sheng. Stainless steel wire mesh - permeability mortar RC Beams research and finite element analysis [D]. Chang'an University, 2010. In Chinese