Computerized Generation Simulation of Straight Bevel Gears with Tangear

Da Qing Li; Yao Min He; Xiao Zhong Deng; Lu Xia Zhang; Xiao Li Zheng

doi:10.4028/www.scientific.net/AMR.711.318

Paper Titles

The Study of Monitoring and Control in the Urban Traffic Noise
p.294

Development of a Molded Case Circuit Breaker with a Spring-Actuated Linkage Based on Multi-Body Dynamics Analysis
p.299

Dynamic Response and Vibration of a Cantilevered Beam under an Accelerated Moving Mass
p.305

Study on Formation Rule of Seismic Wavelet in Kelvin Medium
p.312

Computerized Generation Simulation of Straight Bevel Gears with Tangear
p.318

Fatigue Research on Welding Joint of the Main Girder in Bridge Crane
p.323

Experimental Study of the Influencing Factors of Elevator Cable Magnetic Flux Leakage Detection Signal
p.327

Analysis of Rock Slope Stability on the Basis of Limit Equilibrium Method
p.333

CFD Study on Inner Fluid Flow of Novel Hydrocyclone
p.338

HomeAdvanced Materials ResearchAdvanced Materials Research Vol. 711Computerized Generation Simulation of Straight...

Computerized Generation Simulation of Straight Bevel Gears with Tangear

Abstract:

In this paper, the generation theory of straight bevel gears with is studied. The movements of machine tool are first analyzed. Based on the meshing theory and differential geometry principle, the mathematic model for the generation of gears is established and the tooth surface equation of straight bevel gears is derived. Computerized simulation of generation process has been done, which lay theoretical foundation for rebuilding of machine tool.