Simulation Analysis of Four Teeth End Mill Cutting Process Based on the FEM Method

Xiao Hang Wan; Jian Gang Wang; Zhao Wei Dong; Jian Ling Shi

doi:10.4028/www.scientific.net/AMR.712-715.619

Paper Titles

XPS and Spectroscopic Ellipsometry Study of Composite SiNx/DLC Prepared by Co-Deposition of RF Magnetron and Filtered Cathodic Arc
p.601

Research on the Processing Method of the Special Tool Pear-Shaped Needle in Spinneret Manufacturing Industry
p.606

Process Optimization and Properties of Laser Cladding High Vanadium High Speed Steel Coatings on Nodular Cast Iron
p.611

Hot Forging Die Composite Manufacturing Technology
p.615

Simulation Analysis of Four Teeth End Mill Cutting Process Based on the FEM Method
p.619

Microstructures and Mechanical Properties of Al-12.7Si-0.7Mg Alloy Welded Joints
p.623

Modeling and Numerical Simulation Research on Hollow Steel Ingot Forging Process of Heavy Cylinder Forging
p.627

Research on Simulation Process of Rock Broken by TBM Hob
p.633

Research on Bending Angels of Laser Peen Forming without Confine Layer
p.637

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 712-715Simulation Analysis of Four Teeth End Mill Cutting...

Simulation Analysis of Four Teeth End Mill Cutting Process Based on the FEM Method

Abstract:

Based on FEM, the paper presents a reasonable four teeth end mill model to simulate the process of metal milling, which uses the adaptive meshing criteria.This model simulates a typical work-piece chip breaking process with different cutting speed and feed ratio, which gets the cutting forces curves and the total status of residual stress distribution.