Investigation of Parameters Relevant to Microcellular Foam Injection Molding

Abstract:

The paper is proposed that we can use single factor experiment method and range analysis method to investigate four technological parameters (Melt temperature, Weight loss, Injection time and Gas content) of the technological parameters in the process of microcellular foam injection molding. By investigating the rules and degree which are obtained from the factors influence on bubbles morphology, it is actually meaningful that we can control and improve the bubbles morphology for improving the capability of Microcellular Foam Injection Molding materials.

• Periodical: Advanced Materials Research (Volumes 785-786)
• Pages: 1041-1045
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.785-786.1041
• Online since: September 2013
• Authors: Luo Hong Deng, Zai Liang Chen, Fei Wang
• Keywords: Bubbles Morphology, Microcellular Foam Injection Molding, Single Factor Experiment, Technological Parameters

References

[1] V. Kumar: Cellular Polymers (1993), 12 (3), p.207.

[2] S.T. Lee, N.S. Ramesh: Polymeric foams mechanisms and materials (CRC Press LLC, New York 2004).

[3] Y D He: Plastic (2004), 33(3), p.8.

[4] L Chen, X Wang, R. Straff and K. Blizard: Polym. Eng. Sci. (2002), 42(6), p.1151.

[5] Kelvin T. Okamoto: Microporous plastic molding technology (Chemical Industry Press, Beijing 2004).

[6] X F Peng: Materials Review(2005), 19(1), p.75.

[7] Z B Xu: submitted to South China University of Technology postdoctoral research report(2003).

[8] Z H Fu, Y C Peng: Plastic(2003), 32(4), p.46.

[9] Y C Peng, M C Guo, L Li and K L Li: Mater. SCI. Lett. (2003), 22(8), p.639.

[10] V. Kumar, N.P. Suh: Polym Eng Sci. (1990), 30, p.1323.

[11] M Favelukis, Z Tadmor and R Semia: AIChE. J. (1999), 45, p.691.

[12] Z L Chen, Y B Cai: Journal of Wuhan University of Technology (2005), 20(1), p.68.