Small Module Design of Ball Mill Main Drive Gear with Φ2.4×10m

Jin Xu; Chun Xia Wang

doi:10.4028/www.scientific.net/AMR.787.490

Paper Titles

Study on the Reverse Designing for Engine's Cylinder Head
p.467

Feasibility Study on Applying a Single Loop-Based Vehicle Detector
p.471

Improvement of Detection Method and Power Supply Device of Vehicle Detector
p.478

Numerical Simulation of Aircraft over Run Arresting System
p.485

Small Module Design of Ball Mill Main Drive Gear with Φ2.4×10m
p.490

Effect of Increasing Rudder Deflection on Rudder Inflow for LNG Vessel in Shallow Water
p.495

CDTAs Based Current-Mode Universal Biquad Filters with Orthogonal Control of Quality Factor and Pole Frequency
p.501

Research on Analysis of Linear Texture
p.508

An Experimental Study on the Correlation between Spray Dispersion Area and Tip Penetration Using an Edge Detection Technique of Images Captured from Highly Pressurized Cr-Di Fuel Injection
p.513

HomeAdvanced Materials ResearchAdvanced Materials Research Vol. 787Small Module Design of Ball Mill Main Drive Gear...

Small Module Design of Ball Mill Main Drive Gear with Φ2.4×10m

Abstract:

In order to improve grinding efficiency and achieve low-power operation, this paper presents the design of main drive gear. Under the premise of ensuring the gear strength, using a large teeth and a small modulus extend the life of the big gear, reduce costs to the optimal economic benefit. Gear layouts with optimization method and the design of the drive part meet the requirements of energy saving, high efficiency, low noise, safety and reliability, with certain application values.